You and me for 4C
Any advise on obtaining or making a 4C collet to #4MT adapter?
Any advice on making a handwheel draw tube for said collet sice? Spindle bore is 1". 5C is for about an inch and a quarter spindle bore [oh, blast...]. |
You and me for 4C
Louis Ohland wrote:
Any advise on obtaining or making a 4C collet to #4MT adapter? Any advice on making a handwheel draw tube for said collet sice? Spindle bore is 1". 5C is for about an inch and a quarter spindle bore [oh, blast...]. I think I would start by buying a MT4 to MT2 or 3 spindle adaptor and having at that with some nice sharp carbide tooling. Should make for a straightforward job. A carbide drill to put an appropriate hole in, and a pressed in pin and the job's done. If you wanted to get all fancy-schmancy you could thread the front end of the sleeve to fit a nut to remove it from the spindle with. Cheers Trevor Jones |
You and me for 4C
Louis Ohland wrote:
Any advise on obtaining or making a 4C collet to #4MT adapter? Any advice on making a handwheel draw tube for said collet sice? Spindle bore is 1". 5C is for about an inch and a quarter spindle bore [oh, blast...]. http://cgi.ebay.com/4C-collet-adapte...c mdZViewItem |
All times are GMT +1. The time now is 11:28 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter