Boyar Schultz 6-12 Direct Drive Spindle Bearings
 

The Spindle Bearings on my Boyar Schultz 6-12 Direct Drive Surface
Grinder need replacing.
I've removed all of the covers and can see the snap ring holding the
front bearing, but can't get it out. I haven't determined how to remove
the motor, but can see the set screws in the flex drive thru tha access
hole in the right side.
Any help would be sincerly appreciated.
Thanks .... Al Basham

Boyar Schultz 6-12 Direct Drive Spindle Bearings
 

On 21 Mar 2006 09:04:49 -0800, "Al Basham" wrote:

The Spindle Bearings on my Boyar Schultz 6-12 Direct Drive Surface
Grinder need replacing.
I've removed all of the covers and can see the snap ring holding the
front bearing, but can't get it out. I haven't determined how to remove
the motor, but can see the set screws in the flex drive thru tha access
hole in the right side.
Any help would be sincerly appreciated.
Thanks .... Al Basham


Locate the plugs on the side of the elevation housing and remove them

Elevate the spindle until you can reach the 4 setscrews.

Remove the bottom two First

Holding the motor..remove the upper two. Pull the motor out the back.

Looking into the back of the spindle housing, you will see the back
side of the spindle and the nut that holds the spindle in the bearing.

Remove the nut

push the spindle out the front of the spindle housing

Using a rod..tap out the rear bearing the same direction as the motor
came out.

Quite simple. Assemble in reverse order

Depending on model year..you may have to remove the elevation screw

Gunner



"A prudent man foresees the difficulties ahead and prepares for them;
the simpleton goes blindly on and suffers the consequences."
- Proverbs 22:3