FA: Mattheson regulator (propane/butane/hydrogen/etc) probably ok for MIG gasses as well
here's the link http://cgi.ebay.com/ws/eBayISAPI.dll...tem=7594445612 nice looking gauge, I know several on this group have built furnaces that run on propane, etc - a regulator like this could be handy - and I believe the actual regulator part is the same for the whole series, just change the inlet connector - if that's correct, a regulator that's good for hydrogen should be good for almost any non-corrosive gas. this one does smell like propane/natural gas - there is that residue from (what's the gas they use to make it smell bad?). Bill www.wbnoble.com to contact me, do not reply to this message, instead correct this address and use it will iam_ b_ No ble at msn daught com *** Free account sponsored by SecureIX.com *** *** Encrypt your Internet usage with a free VPN account from http://www.SecureIX.com *** |
All times are GMT +1. The time now is 11:24 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter