drop forged/pressed steel ?
 

Hello,

Does anyone know what is the difference between drop forged and pressed
steel (for scaffold couplers)? I mean what is the difference in the
manufacturing process?

Thanks

So what does the "drop" mean?

Peter

According to :
So what does the "drop" mean?

The upper part of the die, a "striker" is quite massive, and is
raised under power, and then released, letting gravity do the job. This
has the advantage that if something is thicker than expected, and can't
be crushed all the way, you don't wind up breaking gearing inside the
system -- the striker just *stops*.

You could even raise it with a hand-cranked system, and release
it by pulling out a pin or something similar. It would just be a lot
slower that way, so you would have to put the workpiece back on to heat
every time you start cranking the striker to its "cocked" position.

Enjoy,
DoN.

--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. | http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---

On 10 Sep 2005 21:03:47 GMT, (DoN. Nichols)
wrote:

According to :
So what does the "drop" mean?

The upper part of the die, a "striker" is quite massive, and is
raised under power, and then released, letting gravity do the job. This
has the advantage that if something is thicker than expected, and can't
be crushed all the way, you don't wind up breaking gearing inside the
system -- the striker just *stops*.

You could even raise it with a hand-cranked system, and release
it by pulling out a pin or something similar. It would just be a lot
slower that way, so you would have to put the workpiece back on to heat
every time you start cranking the striker to its "cocked" position.

Enjoy,
DoN.

Hmmm. Dad rigged something like that once. However, it sucked for
its intended use. He rigged up a trip to drop one of our levee
rollers from the winch truck with the idea of flattening some old cars
for the junkman. The trip just had a notch to hold the chain around
the spool, and a 3' handle welded to it with a long rope. He winched
up the roller, backed it over our old Travelall, and then dropped the
roller (concrete spool about 2 tons). The car wrapped around that
thing like a coke can stuck on your heel. It took quite a while to
cut it loose.

Pete Keillor

"Christopher Tidy" .(clip) I would guess that the forged couplers will be
stronger. Forgings are usually very strong because of the alignment of the
grains in the metal.
^^^^^^^^^^^^^^^^^
Another reason forgings are generally stronger is that the dies can be
shaped so that the metal varies in thickness as needed for strength.
Reinforcing webs and radii can be designed in, to reduce stress, increase
stiffness and improve fatigue life. In a stamping, the dies can stretch the
material, making it thinner, but they can't make it thick and strong next to
a hub, for example.

Remember Junkyard Wars? There was an episode on curshing a car to a
particular height and one of the teams built a drop hammeer setup for doing
this and they won. The other team build a press and it broke several times.

--
Why do penguins walk so far to get to their nesting grounds?