Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Servicing an old Lincoln Idealarc 250 ?
You win some and you lose some. On eBay, I scored an old AC/DC Idealarc 250
(the kind with the round corners, not the current rectangular model). The adjustment crank turns very smoothly. The power switch sounds fine. The polarity switch is a little tight, but seems to work. Surprisingly, Lincoln has the manual on their web page. It gives instructions for lubricating the crank. I'm going to remove the cover this weekend and do that. Is there anything else I should do while I'm inside? I'll blow it out and try to clean the fan as well. Should I try to clean the switches? The data plate says 208V, which is good because that's what I have. If later on I decide to run it on 230V would that cause any problems? Oh, by the way, I also scored a giant welding table. |
#2
|
|||
|
|||
Over the years I have used several of those old machines. I never
encountered one that didn't work. 208 will work with 230. If you put a meter on your power you will find quite a variation in voltage over the day and season. Some areas are worse than others. Off voltage can cause problems with the life of an electric motor but not a welding machine like the Idealarc. Randy "Albert1234" wrote in message ... You win some and you lose some. On eBay, I scored an old AC/DC Idealarc 250 (the kind with the round corners, not the current rectangular model). The adjustment crank turns very smoothly. The power switch sounds fine. The polarity switch is a little tight, but seems to work. Surprisingly, Lincoln has the manual on their web page. It gives instructions for lubricating the crank. I'm going to remove the cover this weekend and do that. Is there anything else I should do while I'm inside? I'll blow it out and try to clean the fan as well. Should I try to clean the switches? The data plate says 208V, which is good because that's what I have. If later on I decide to run it on 230V would that cause any problems? Oh, by the way, I also scored a giant welding table. |
#3
|
|||
|
|||
Congratulations. I have the identical model. It is a wunnerful
machine. V |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Stick cable for Lincoln TIG 185 | Metalworking | |||
Lincoln AC/DC Tig- Idealarc Tig 250/250 question | Metalworking | |||
Lincoln Idealarc 250/250 AC/DC/ Tig question | Metalworking | |||
I want to add a pulser to my Lincoln TIG | Metalworking | |||
Lincoln SP-135T feed problem | Metalworking |