Drilling through a steel pipe.
"MatGyver" wrote in message om... This is probably a very simple question to answer, but any help would be appreciated. My wife and are doing a few DIY artsy fartsy projects, and I need to drill some small holes (about 1/4 of an inch) in some steel plumbing pipe we bought at lowes. I haven't measured, but I'm guessing the pipe is no more than and 1/8 of an inch thick, probably not even that thick. What kind of drill bit would I need to use. All I have are standard wood bits that I imagine will probably break if I try to use them. Thanks in advance! Use what is considered to be a standard jobbers length twist drill, made of high speed steel. They are usually marked HSS. Speed can kill the drill, so run it at a modest speed. For a ¼" drill you should be fine at about 1,000 RPM. Standard steel pipe is only mild steel, but the radius of the pipe makes it difficult to start the hole where you want it. If you have the luxury of a drill press, use it. If you must drill by hand, make a generous center pop to help you start the hole. Drilling a smaller hole first often helps, so consider drilling first with a 1/8" drill. It's easy to open up the hole once you have it established. Don't use your wood type drills on steel unless they are a standard twist drill. While many of the drills made for wood are made of HSS, their geometry does not lend them to drilling in steel the way a twist drill does. Hope this helps. Harold |
Drilling through a steel pipe.
If you are talking about drilling into the side of a long piece of pipe,
it is probably easier to use a pistol drill. Using a variable speed drillmotor, it is possible to start the hole without center punching, by placing the tip of the drill against the pipe, and then bringing the speed up gradually. Don't forget that the drill will snag as you break through. This is inevitable when drilling into pipe as the drill breaks through at different time around the circumference of the hole due to the curvature of the pipe wall. The closer the pipe bore to the hole size, the worse the problem. If you're using a pistol drill, be ready for the kick. John |
Drilling through a steel pipe.
Others have mentioned HSS drill bits - basically the standard twist drill
bits that you find everywhere that make a hole bottom that is tapered. IN addition, get a punch so you can make a dimple in the pipe where you want to do the drilling. This will keep the drill from wandering about before it starts digging in. A drill press, if you don't have one, will be a welcome addition for this drilling as metal wants a lot more pressure on the drill bit than wood does. You want to make the metal come out of the hole as two long strings if you keep pressing all the way through. In addition, keep a pot of oil (anything cheap including the scrap oil out of your car's engine) at hand with a acid brush in it so that you can dab some on the metal to help the drilling. -- There are more Democrats on the Calif. Special Election than Republicans! Go count if you don't believe me! Bob May |
Drilling through a steel pipe.
Thanks everyone for your help!
|
All times are GMT +1. The time now is 02:36 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter