Prototyping and short run
Hi all,
I am looking for someone in the south eastern PA area to do some prototype/short run machining. I tried emachineshop.com with less than spectacular results (first attempt NPT thread way too deep -Second attempt NPT crooked by 15 degrees). The part is not especially complex. Basically it is 2" length of about 3" round cut on 2 sides to make a sort of oval. Drilled holes include (2) 1/4" through holes. Drilled and threaded include a single 1/2 NPT threaded blind hole and a single 3/8" NPT threaded hole that intersects with the blind 1/2 NPT hole. I know this is vague but I wanted to give a general idea of my needs. Thanks, Steve |
If you don't have any luck, and want to deal w/ an OK short run guy in NYC,
email me and I'll put you in touch w/ my ole compadre. UPS can actually make samples pretty painless. ---------------------------- Mr. P.V.'d formerly Droll Troll wrote in message oups.com... Hi all, I am looking for someone in the south eastern PA area to do some prototype/short run machining. I tried emachineshop.com with less than spectacular results (first attempt NPT thread way too deep -Second attempt NPT crooked by 15 degrees). The part is not especially complex. Basically it is 2" length of about 3" round cut on 2 sides to make a sort of oval. Drilled holes include (2) 1/4" through holes. Drilled and threaded include a single 1/2 NPT threaded blind hole and a single 3/8" NPT threaded hole that intersects with the blind 1/2 NPT hole. I know this is vague but I wanted to give a general idea of my needs. Thanks, Steve |
All times are GMT +1. The time now is 09:28 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter