Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
help with lathe wiring
I set up my new HF 12x36 metal lathe tonight. It came pre-wired
except for the plug end. I added a plug end and tried to power up the lathe but nothing happens. There are 3 buttons and a light on the front of my lathe. A power light which is always lit when the breaker is on. A reset button which pops out when I twist it. a power button which does nothing when I press it and an inch button which does nothing when I press it. If I go into the power panel on the back of the lathe and manually press the small black button on the third power relay the lathe kicks on and runs fine. It then stops when I press the reset button. The little black button pops back out, but when I press power, still nothing. I am twisting the reset button before trying again. Any ideas? Thanks, Nick |
#3
|
|||
|
|||
help with lathe wiring
Problem solved. It helps when they give you the correct manaul. The
one they sent me was for a completely different lathe. I downloaded the correct version and the lathe works fine. (Nick) wrote in message . com... I set up my new HF 12x36 metal lathe tonight. It came pre-wired except for the plug end. I added a plug end and tried to power up the lathe but nothing happens. There are 3 buttons and a light on the front of my lathe. A power light which is always lit when the breaker is on. A reset button which pops out when I twist it. a power button which does nothing when I press it and an inch button which does nothing when I press it. If I go into the power panel on the back of the lathe and manually press the small black button on the third power relay the lathe kicks on and runs fine. It then stops when I press the reset button. The little black button pops back out, but when I press power, still nothing. I am twisting the reset button before trying again. Any ideas? Thanks, Nick |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Logan Lathe Tool Gloat | Metalworking | |||
What lathe must I get to duplicate this fog horn part? | Metalworking | |||
Book for Turret Lathe | Metalworking | |||
Moving a Lathe | Metalworking |