Bending AL diamond plate
If anyone has suggestions on how to achieve a smooth bend, I'm all ears.
The plate is 1/8 inch thick, and the finished piece will be about 8 x 12 inches with a bend radius of about one foot. Thanks for any help. -- Ted Bennett |
Put a sheet of 1/4" or so rubber on the diamond side and run it
through sheetmetal rollers. Use lots of passes to sneak up on the diameter you want. You may need to work the edges a bit if you want them curved as well. Cheers, Kelley On Wed, 13 Jul 2005 16:04:26 GMT, Ted Bennett wrote: If anyone has suggestions on how to achieve a smooth bend, I'm all ears. The plate is 1/8 inch thick, and the finished piece will be about 8 x 12 inches with a bend radius of about one foot. Thanks for any help. |
1/8 inch aluminum ought to bend fairly easily. If you have sheet
metal , I would expect you could bend it without using the rubber sheeting suggested by Kelley. If I were doing this with what I have available, I think I would try laying a 5 gallon propane tank on its side and seeing if I could bend it with a few ratcheting web straps. Not very high tech, but what I would try first. A five gallon propane tank may have a bit too small a radius. You might have something better. Dan |
All times are GMT +1. The time now is 02:21 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter