Myford larger feed dial article?
 

--Can't remember what zine, what issue it was in; anyone got a
pointer? Also looking for source of larger feed dials; found one in the
PIC Design catalog, but not sure if it's appropriate to the job.
--TIA,

--
"Steamboat Ed" Haas : Quando Omni
Hacking the Trailing Edge! : Flunkus Moritati
http://www.nmpproducts.com/intro.htm
---Decks a-wash in a sea of words---

Myford larger feed dial article?
 

steamer wrote:

--Can't remember what zine, what issue it was in; anyone got a
pointer? Also looking for source of larger feed dials; found one in the
PIC Design catalog, but not sure if it's appropriate to the job.
--TIA,

--
"Steamboat Ed" Haas : Quando Omni
Hacking the Trailing Edge! : Flunkus Moritati
http://www.nmpproducts.com/intro.htm
---Decks a-wash in a sea of words---

Try this..

http://yarchive.net/metal/books.html

It's still good advice, same as when it was given you the first time.
:-P

Cheers
Trevor Jones

The GHT books are GREAT!

Myford larger feed dial article?
 

Back in the 1970s, Model Engineer had a series about them. One of the firms
that advertised in the magazine produced a kit.

Steve Rayner.


"steamer" wrote in message
...
--Can't remember what zine, what issue it was in; anyone got a
pointer? Also looking for source of larger feed dials; found one in the
PIC Design catalog, but not sure if it's appropriate to the job.
--TIA,

--
"Steamboat Ed" Haas : Quando Omni
Hacking the Trailing Edge! : Flunkus Moritati
http://www.nmpproducts.com/intro.htm
---Decks a-wash in a sea of words---