Looking for somebody in the UK to make an internal threaded brass 45mm dia tube
 

I have a one-off private job that I am looking for somebody in the UK
to make. I don't have much of a budget and have no idea where to find
somebody to make this sort of thing for me so am looking for
suggestions of a UK individual that can make it on this group.

Also, is there a kind of task/contractor contact web site for one-off
jobs like this?

Anyway, the following as what I need made :

Tube diamet 45mm (approx)
Material: Brass, Copper SS (anything non-rusting)
Thread length: about 1cm max
Thread: 1 and 9/16 ths inch (15.625mm), whitworth
Internal thread inside tube at one end
Tube length: 12cm min, 50cm ideal

Can anyone here help?

Peter

Duh, I meant 1 and 9/16ths (39.6875mm) !

Shouldn't be too much of a problem. I'm no screwcutting expert and think
a bit more detail on the thread is needed. If no-one else contacts you
direct I know a guy who might help. Or I could have a go.

Regards
Rob



In message , Peter
writes
Duh, I meant 1 and 9/16ths (39.6875mm) !

"Peter" wrote in message
...
I have a one-off private job that I am looking for somebody in the UK
to make. I don't have much of a budget and have no idea where to find
somebody to make this sort of thing for me so am looking for
suggestions of a UK individual that can make it on this group.

Also, is there a kind of task/contractor contact web site for one-off
jobs like this?

Anyway, the following as what I need made :

Tube diamet 45mm (approx)
Material: Brass, Copper SS (anything non-rusting)
Thread length: about 1cm max
Thread: 1 and 9/16 ths inch (15.625mm), whitworth
Internal thread inside tube at one end
Tube length: 12cm min, 50cm ideal

Can anyone here help?

Peter

Try posting on uk.rec.models.engineering

Thanks Rob,I am not sure if you spam-trap all mail from usenet but I
tried to send an email to you.