DIYbanter - Bathroom renovation help

wrote:
I'm getting ready to do a partial bathroom renovation and have some
plumbing questions. I pretty much just want to make sure that my
assumptions are correct and I'm not going to get any surprises when I
open up the wall to get at the plumbing.
I have a fiberglass shower stall and a whirlpool bathtub on the same
side of the bathroom. I am pulling out the very small shower stall
and moving the shower so that it is in the tub. Looking at that side
of the bathroom, the shower stall is on the left with the plumbing on
the left wall, then there is about 18" of wall space followed by a
whirlppool tub in a tiled enclosure. The tub plumbing is also on the
left side. [With an 18" wide wall in between the two units, is
there any valid reason they would not have just out the plumbing back
to back?]

- I am assuming that the stall drain is connected to the tub drain
and that I can easily (hopefully) cap it off.

- I am assuming that the water lines to the stall connnect with the
lines for the tub and that I can rip those out and, best case, cap any
stubs, worst case put in a new length of pipe to remove the stall
connections.

- I also expect that adding a shower to the existing plumbing for the
tub is not a big deal. Pretty much just replacing the current tap
setup with one that allows for a shower extension.

- I am also assuming that there is no functional reason that there is
18" of wall space between the shower stall and tub. That this wall
just needs to be wide enough to hold the plumbing.

Does everything sound right? Are there lurking gotchas that I haven't
thought of? Ok, there are always lurking gotchas. What might they
be?

Thanks,

George

That is a lot of assuming there. I can't see inside your walls so I
can't really guess. You need a good plumber in there to take a look and
tell you what he thinks.

--
Joseph Meehan

26 + 6 = 1 It's Irish Math