DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Home Repair (https://www.diybanter.com/home-repair/)
-   -   GFCI Tripping constantly (https://www.diybanter.com/home-repair/79197-gfci-tripping-constantly.html)

barry martin November 29th 04 02:27 PM

GFCI Tripping constantly
 
Mark:

M I woke up this morning, took a shower. When I went to shave I noticed that
M the GFCI receptacle in my bathroom had tripped. I pushed the "RESET" button
M back in but it immediately popped back out. Tried it about 10 more

Does this GFCI also power the outlet(s) for your outdoor Christmas
lights? If the lights work and your GFCI doesn't then that's not the
problem site. If the lights are also shut off then unplugging the
lights may or may not solve the problem: rainwater could have gotten
into the outlet box.

M times...kept happening. I remember reading on this NG years ago about this,
M and so I checked the "downstream" receptacle - which I'm assuming is just
M the other bathroom in my house which is adjacent to this one on the opposit

M wall (if that makes sense). That is not a GFCI receptacle, but it must be
M downstream of the GFCI in my bathroom because there is no longer any power
M to that receptacle either.

OK, so we have 'proved' the outlet in the other bathroom is powered
from the GFCI in your bathroom. Outlets downstream are protected by
the one GFCI and are usually regular outlets. (Hopefully while you
are experiencing this problem you are mapping the circuits and posting
it by the service panel. Two years from now when someone is in the
adjacent bathroom and the GFCI in your bathroom trips are you going to
remember or are they going to know if you are not around to reset the
GFCI in your batyhroom to fix their bathroom's problem? The circuit
breaker will not be tripped.)




M There is nothing plugged in anymore to either of these outlets, yet the GFC

M keeps tripping. My guess is, the GFCI has gone bad - it is most likely 20
M years old, as my house is 20 years old and I'm the 2nd owner (been here
M about 4 years), and the receptacle quite frankly looks old (if that is of
M any relevance).

It is possible for a GFCI to wear out or become overly sensitive --
the new GFCIs are better anyway, so wouldn't hurt to change it out.
Just remember to shut off the circuit breaker providing power to the
GFCI (line side).


M So how should I proceed? I have knowledge of electrical safety (ie, how not
M to get electrocuted, and how to use a meter). I also have basic wiring
M skills/tools, so my thought to was to buy a new GFCI and install it.
M However, there is one thing I'm concerned about:
M
M Yesterday the wife and I put up all of the Christmas lights outside. And of
M course right afterward, here in the Philadelphia area, it started raining
M and has ever since. So I'm concerned that perhaps the christmas lights (the
M standard series-wired little bulb things) are somehow playing into this. If
M not, then it's just odd coincidence? Those lights are not connected to the
M GFCI and are not "downstream" so I don't see how they could affect it. Come
M to think of it, I need to go check to make sure those still work - I haven'

M plugged them in yet today.

Assuming by now you have determined either the lights are on the GFCI
or not.


M For the time being - how should I troubleshoot this? Should I just go ahead
M and replace the GFCI receptacle?

Ckt breaker === your bath lights
|
=== your bath GFCI
|
==== adjacent bath's outlet
?
==== to outside lights?
?
==== to anything else?

The GFCI has LINE and LOAD terminals. The LINE terminals go to
circuit breaker (power in). The LOAD terminals go to the downstream
outlets.

-
¯ barry.martinþATþthesafebbs.zeppole.com ®

* "Who stole my thermal underwear?" the hunter said coldly.
---
þ RoseReader 2.52á P003186
þ The Safe BBS þ Bettendorf, IA 563-359-1971
---
þ RIMEGate(tm)/RGXMod V1.13 at BBSWORLD *

Salty Thumb November 29th 04 03:58 PM


M I woke up this morning, took a shower. When I went to shave I
noticed that M the GFCI receptacle in my bathroom had tripped. I
pushed the "RESET" button M back in but it immediately popped back
out. Tried it about 10 more
?
==== to anything else?


this happened to me recently. replaced the gfci, same problem. replaced a
downstream outlet and gfci worked normally.

Salty Thumb November 29th 04 04:02 PM

Salty Thumb wrote in
news:nOGqd.7021$xk5.3407@trnddc09:


M I woke up this morning, took a shower. When I went to shave I
noticed that M the GFCI receptacle in my bathroom had tripped. I
pushed the "RESET" button M back in but it immediately popped back
out. Tried it about 10 more ?
==== to anything else?


this happened to me recently. replaced the gfci, same problem.
replaced a downstream outlet and gfci worked normally.


p.s. it goes without saying, but make sure you cut the right circuit
breaker before fooling with it or it'll end your holiday real quick

mark November 30th 04 04:10 AM

Thanks to all who replied.

The outside lights are not connected to the GFCI.

A couple of hours after I posted the original problem, I went upstairs and
reset the GFCI and it worked. And has since then (a full day). So I'm not
sure what the problem is/was.

mark

"Salty Thumb" wrote in message
news:SRGqd.7098$xk5.696@trnddc09...
Salty Thumb wrote in
news:nOGqd.7021$xk5.3407@trnddc09:


M I woke up this morning, took a shower. When I went to shave I
noticed that M the GFCI receptacle in my bathroom had tripped. I
pushed the "RESET" button M back in but it immediately popped back
out. Tried it about 10 more ?
==== to anything else?


this happened to me recently. replaced the gfci, same problem.
replaced a downstream outlet and gfci worked normally.


p.s. it goes without saying, but make sure you cut the right circuit
breaker before fooling with it or it'll end your holiday real quick




Steve@carolinabreezehvac November 30th 04 05:48 AM


"mark" wrote in message
news:xwRqd.1809$nq6.143@trndny09...
Thanks to all who replied.

The outside lights are not connected to the GFCI.

A couple of hours after I posted the original problem, I went upstairs and
reset the GFCI and it worked. And has since then (a full day). So I'm not
sure what the problem is/was.

mark



Here is something to try..

Go in, turn the shower on hot, and leave for a few minutes....see if it does
it again, and if so, you found your issue..

"Salty Thumb" wrote in message
news:SRGqd.7098$xk5.696@trnddc09...
Salty Thumb wrote in
news:nOGqd.7021$xk5.3407@trnddc09:


M I woke up this morning, took a shower. When I went to shave I
noticed that M the GFCI receptacle in my bathroom had tripped. I
pushed the "RESET" button M back in but it immediately popped back
out. Tried it about 10 more ?
==== to anything else?

this happened to me recently. replaced the gfci, same problem.
replaced a downstream outlet and gfci worked normally.


p.s. it goes without saying, but make sure you cut the right circuit
breaker before fooling with it or it'll end your holiday real quick





Islander December 6th 04 11:18 PM

On Mon, 29 Nov 2004 23:48:03 -0500, "Steve@carolinabreezehvac"
wrote

20 yrs for gfci is well beyond its lifespan, not factoring bathroom
humidity. So probably 15 yrs is a good estimate, but probably NEMA or
UL will have more details, but here is what CSPC has on it.

http://www.cpsc.gov/volstd/gfci/AnalysisGFCI.pdf

I suggest replace all your gfci while your at it, around $10.


"mark" wrote in message
news:xwRqd.1809$nq6.143@trndny09...
Thanks to all who replied.

The outside lights are not connected to the GFCI.

A couple of hours after I posted the original problem, I went upstairs and
reset the GFCI and it worked. And has since then (a full day). So I'm not
sure what the problem is/was.

mark



Here is something to try..

Go in, turn the shower on hot, and leave for a few minutes....see if it does
it again, and if so, you found your issue..

"Salty Thumb" wrote in message
news:SRGqd.7098$xk5.696@trnddc09...
Salty Thumb wrote in
news:nOGqd.7021$xk5.3407@trnddc09:


M I woke up this morning, took a shower. When I went to shave I
noticed that M the GFCI receptacle in my bathroom had tripped. I
pushed the "RESET" button M back in but it immediately popped back
out. Tried it about 10 more ?
==== to anything else?

this happened to me recently. replaced the gfci, same problem.
replaced a downstream outlet and gfci worked normally.

p.s. it goes without saying, but make sure you cut the right circuit
breaker before fooling with it or it'll end your holiday real quick






All times are GMT +1. The time now is 12:42 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter