DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Home Repair (https://www.diybanter.com/home-repair/)
-   -   High efficiency furnace - water out of outside pipe (https://www.diybanter.com/home-repair/74106-high-efficiency-furnace-water-out-outside-pipe.html)

No October 21st 04 11:48 PM

High efficiency furnace - water out of outside pipe
 
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and
there were 2 PVC pipes put outside my house - one is for taking air into
furnace and another one for air out of furnace. When furnace is working, my
second pipe is spraying water out of it - not a lot, but still hand feels
wet if you hold up to it. It seems kind of strange. Is that a good furnace
installation? Should it be like that? If yes, then would it not freeze in
the winter?

Thanks



MLD October 21st 04 11:55 PM

I know at times that the vent pipe does show some signs of water droplets
near the end of the pipe. I take this to mean that not all of the moisture
has been removed from the exhaust air of the furnace and as such condenses
near the end of the pipe. As far was water spraying, haven't seen that. Is
your condensate pump system working because that is where all the moisture
should end up. BTW, look at the way the pipes are installed, they should be
in a slight angle up towards the outside.
MLD
"No" wrote in message ...
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and
there were 2 PVC pipes put outside my house - one is for taking air into
furnace and another one for air out of furnace. When furnace is working,

my
second pipe is spraying water out of it - not a lot, but still hand feels
wet if you hold up to it. It seems kind of strange. Is that a good furnace
installation? Should it be like that? If yes, then would it not freeze in
the winter?

Thanks





James Owens October 22nd 04 04:08 AM


Our high-efficiency furnace develops an icicle stalagmite below the
exhaust pipe in winter. We have to knock it down around February to
prevent it from enveloping the pipe.



"No" ) writes:
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and
there were 2 PVC pipes put outside my house - one is for taking air into
furnace and another one for air out of furnace. When furnace is working, my
second pipe is spraying water out of it - not a lot, but still hand feels
wet if you hold up to it. It seems kind of strange. Is that a good furnace
installation? Should it be like that? If yes, then would it not freeze in
the winter?

Thanks




--
"For it is only of the new one grows tired. Of the old one never tires."
-- Kierkegaard, _Repetition_

James Owens, Ottawa, Canada

TURTLE October 22nd 04 06:15 AM


"No" wrote in message ...
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and there
were 2 PVC pipes put outside my house - one is for taking air into furnace and
another one for air out of furnace. When furnace is working, my second pipe is
spraying water out of it - not a lot, but still hand feels wet if you hold up
to it. It seems kind of strange. Is that a good furnace installation? Should
it be like that? If yes, then would it not freeze in the winter?

Thanks


This is Turtle.

The vapor being very moist is normal and is working fine. These vapors was at
2,000ºF when it was in the furnace but the furnace takes so much of the heat out
of the vapors that it makes water drop out of the vapors and will be sometimes
at about 80ºF or so.

Now i have rarely ever seen the vapor close off the pipe but have seen a good
amount of ice from where they drip off the end of the pipe.

TURTLE



BGBevill October 22nd 04 03:10 PM

"No" wrote in message ...
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and

there
were 2 PVC pipes put outside my house - one is for taking air into furnace

and
another one for air out of furnace. When furnace is working, my second pipe

is
spraying water out of it - not a lot, but still hand feels wet if you hold

up
to it. It seems kind of strange. Is that a good furnace installation?

Should
it be like that? If yes, then would it not freeze in the winter?

Thanks


This is Turtle.

The vapor being very moist is normal and is working fine. These vapors was at

2,000ºF when it was in the furnace but the furnace takes so much of the heat
out
of the vapors that it makes water drop out of the vapors and will be
sometimes
at about 80ºF or so.

Now i have rarely ever seen the vapor close off the pipe but have seen a good

amount of ice from where they drip off the end of the pipe.

TURTLE



Dang Turtle, didn't know it got that cold down there in your area....;-).
Yeah, the furnace seems to be fine. What you are seeing and/or feeling is
normal as Turtle said.

Bobby

m Ransley October 22nd 04 04:41 PM

Some water vapor is normal, you say spraying water though. Im sure
Carrier can tell you how much is normal, an improperly angled exhaust
is possible as is maybe [ Im guessing ] improper furnace angle for
draining. My PVC exhaust does not freeze at - 20f and properly
instaled they should rarely freeze. Im sure they are used where it gets
to -60F. Water vapor is normal as 93% of the heat is removed and NG
contains allot of water. That is why you cannot vent HE furnaces
through an unlined chimney, water and acid will eat brick. If you
really drip water it may be of concern. Check the level of the exhaust
and call Carrier to see what they recommend and how to check things
out. Your furnace drains water from combustion, check that also.


TURTLE October 24th 04 10:15 PM


"BGBevill" wrote in message
...
"No" wrote in message ...
Hi,

I recently had High Efficiency furnace installed (Carrier Infinity) and

there
were 2 PVC pipes put outside my house - one is for taking air into furnace

and
another one for air out of furnace. When furnace is working, my second pipe

is
spraying water out of it - not a lot, but still hand feels wet if you hold

up
to it. It seems kind of strange. Is that a good furnace installation?

Should
it be like that? If yes, then would it not freeze in the winter?

Thanks


This is Turtle.

The vapor being very moist is normal and is working fine. These vapors was at

2,000ºF when it was in the furnace but the furnace takes so much of the heat
out
of the vapors that it makes water drop out of the vapors and will be
sometimes
at about 80ºF or so.

Now i have rarely ever seen the vapor close off the pipe but have seen a good

amount of ice from where they drip off the end of the pipe.

TURTLE



Dang Turtle, didn't know it got that cold down there in your area....;-).
Yeah, the furnace seems to be fine. What you are seeing and/or feeling is
normal as Turtle said.

Bobby


This is Turtle.

Yea, We have a weather forcaster that has stated that we may get some ice in the
water in the ditches along side the roads by Jan. or Feb.. It has been laterly
getting in the 80's and 90's during the day and 70's at nite. Everybody will
crank up there heating furnaces to see if the work a little before Christmas
before the winter sets in. I try to get all my customers to do this at Thank
Giving to be a head of the game.

TURTLE




All times are GMT +1. The time now is 05:16 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter