Kenmore Washer Won't Drain
We have an older Kenmore 70 Series washing machine, model 110.72770100.
A few weeks ago it randomly stopped draining. Most of the time it works fine, but maybe one load out of five the tub is still full of water when the cycle is over. I replaced the lid switch, but the problem continued. We also had one load when the washer actually overflowed onto the floor. So, I replaced the timer, the water pump, and the fill valve. There were no obstructions in any of the hoses and the drive belt is in good condition. But, occasionally it still doesn't drain and spin properly. Any ideas what would cause this? Thanks, Anthony Watson www.mountainsoftware.com www.watsondiy.com |
Kenmore Washer Won't Drain
On Monday, June 8, 2015 at 9:00:12 AM UTC-4, HerHusband wrote:
We have an older Kenmore 70 Series washing machine, model 110.72770100. A few weeks ago it randomly stopped draining. Most of the time it works fine, but maybe one load out of five the tub is still full of water when the cycle is over. I replaced the lid switch, but the problem continued. We also had one load when the washer actually overflowed onto the floor. So, I replaced the timer, the water pump, and the fill valve. There were no obstructions in any of the hoses and the drive belt is in good condition. But, occasionally it still doesn't drain and spin properly. Any ideas what would cause this? Thanks, Anthony Watson www.mountainsoftware.com www.watsondiy.com Sounds like you already replaced all the parts involved. Only obvious thing left is a loose connection somewhere in the wiring. I'd follow the wiring diagram and check all connections. If you don't find anything doing that, then I'd catch it when it's misbehaving and probe it out. All those parts must have cost quite a bit of the cost of a new machine. |
Kenmore Washer Won't Drain
On 6/8/2015 8:58 AM, HerHusband wrote:
I replaced the lid switch, but the problem continued. We also had one load when the washer actually overflowed onto the floor. So, I replaced the timer, the water pump, and the fill valve. There were no obstructions in any of the hoses and the drive belt is in good condition. But, occasionally it still doesn't drain and spin properly. Any ideas what would cause this? You did everything I'd have done. Check for corroded connections someplace. You replaced most everything electrical already, but if there is a wire to something that is not contacting properly, that will negate the other parts. Depending on the age of the machine, unless I was sure it was fixed I'd consider replacing it rather than throw more money at it. . |
Kenmore Washer Won't Drain
Or, get yer wife off her fat ass and make her wash yer ****ty undies.
LOL |
All times are GMT +1. The time now is 01:54 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter