tool for joining garden hoses
 

Is there a tool for helping to join (i.e repair) 2 sections of garden hoses. Getting one side of plastic connector into one section is relatively easy but getting the other side into other piece far enough is not.

tool for joining garden hoses
 

On Fri, 26 Jul 2013 19:27:19 -0700 (PDT), Frank Thompson
wrote:

Is there a tool for helping to join (i.e repair) 2 sections of garden hoses. Getting one side of plastic connector into one section is relatively easy but getting the other side into other piece far enough is not.

I've never had a problem. Maybe badly made connectors, or one hose is
the wrong size?
If you have "strength" problem, try lubing the connector with veg oil
or silicone lube to make it slide on easier.

tool for joining garden hoses
 

In article ,
Vic Smith wrote:

On Fri, 26 Jul 2013 19:27:19 -0700 (PDT), Frank Thompson
wrote:

Is there a tool for helping to join (i.e repair) 2 sections of garden hoses.
Getting one side of plastic connector into one section is relatively easy
but getting the other side into other piece far enough is not.

I've never had a problem. Maybe badly made connectors, or one hose is
the wrong size?
If you have "strength" problem, try lubing the connector with veg oil
or silicone lube to make it slide on easier.

Agreed... or soak the obstinate end in hot water. As always, use all
appropriate caution, common sense & good judgment.

Erik

tool for joining garden hoses
 

On Friday, July 26, 2013 9:27:19 PM UTC-5, Frank Thompson wrote:
Is there a tool for helping to join (i.e repair) 2 sections of garden hoses. Getting one side of plastic connector into one section is relatively easy but getting the other side into other piece far enough is not.

I always soak the plastic hose ends in boiling(almost) hot water to really soften them up, then a little vaseline or other lubricant and the hose ends slide on the fitting real easily.

Frank:
Garden hose typically comes in both 1/2 and 5/8 inch ID sizes. You may be trying to push a 1/2 inch hose onto a 5/8 inch connector.

What I always do whenever pushing fittings into plastic hose is boil a pot of water. Leave the end of the hose in the hot water for 20 to 30 seconds or so, and it'll be soft enough to push over your fitting easily. I've done this with 1 inch plastic water hose, and it works like a charm.

Make sure you have any clamps you intend to use on the joint on the hose before soaking the end of the hose in hot water.

tool for joining garden hoses
 

"nestork" wrote in message

stuff snipped

Make sure you have any clamps you intend to use on the joint on the hose
before soaking the end of the hose in hot water.

It's like soldering. The most perfect solder joint you'll ever make is one
you'll have to break to get the connector sleeve you forgot to slide on the
wire back on.

--
Bobby G.

tool for joining garden hoses
 

I've done that, with 1/4 phono plugs. And 1/8. Anyone old enough to
remember those?

..
Christopher A. Young
Learn more about Jesus
www.lds.org
..
..

On 7/27/2013 5:23 AM, Robert Green wrote:

Make sure you have any clamps you intend to use on the joint on the hose
before soaking the end of the hose in hot water.

It's like soldering. The most perfect solder joint you'll ever make is one
you'll have to break to get the connector sleeve you forgot to slide on the
wire back on.

--
Bobby G.