Tile Saw Question
 

I got a large tile saw. The bed is about 24 , 36 inches, the blade,
probably around ten inches. The depth of cut allows me to cut standard
pavers, about the thickness of a brick, 2.5". My other one would not cut
that deep.

I have a lot of right angle cuts to trim some that are just too long. I am
also going to make a part of the path curved, so will need to cut some on
the angle.

How does one hold the paver in place during sawing when it is at an angle?
I can build an adjustable bevel miter out of steel, as I have a band saw and
MIG and all that stuff. Is there a holder available that isn't expensive,
or some simple way to do this that would be accurate and safe?

Steve

visit my blog at http://cabgbypasssurgery.com

Tile Saw Question
 

On Sun, 1 Aug 2010 09:15:40 -0700, "Steve B"
wrote:

I got a large tile saw. The bed is about 24 , 36 inches, the blade,
probably around ten inches. The depth of cut allows me to cut standard
pavers, about the thickness of a brick, 2.5". My other one would not cut
that deep.

I have a lot of right angle cuts to trim some that are just too long. I am
also going to make a part of the path curved, so will need to cut some on
the angle.

How does one hold the paver in place during sawing when it is at an angle?
I can build an adjustable bevel miter out of steel, as I have a band saw and
MIG and all that stuff. Is there a holder available that isn't expensive,
or some simple way to do this that would be accurate and safe?

Don't know how your tile saw is laid out, but mine has a sliding table and
fixed saw. Tile, pavers, and such aren't likely to bind and kick, so even
freehand angles work (I use this for the circle-of-a-thousand-cuts method).
Some tile saws I've seen have a fixed table and a sliding saw. These should
work similarly. If you have a constant angle to make on many bricks, I'd just
make the appropriate wedge out of wood.

Tile Saw Question
 

"Steve B" wrote:

I got a large tile saw. The bed is about 24 , 36 inches, the blade,
probably around ten inches. The depth of cut allows me to cut standard
pavers, about the thickness of a brick, 2.5". My other one would not cut
that deep.

I have a lot of right angle cuts to trim some that are just too long. I am
also going to make a part of the path curved, so will need to cut some on
the angle.

How does one hold the paver in place during sawing when it is at an angle?
I can build an adjustable bevel miter out of steel, as I have a band saw and
MIG and all that stuff. Is there a holder available that isn't expensive,
or some simple way to do this that would be accurate and safe?

I was thinking of you when I saw what this guy threw together to make
compound cuts on bricks for a pizza oven-
http://www.fornobravo.com/forum/f28/...ool-12478.html

Jim

Tile Saw Question
 

In article ,
says...

I got a large tile saw... How does one hold the paver in place during
sawing when it is at an angle?


My sliding table tile saw has two separate fixtures. An adjustable miter
gauge like a table saw, and an aluminum wedge for bevel cuts. The wedge
is not adjustable, it's just at a 45.

--
DT