Tips on Unscrewing Kitchen Sink Waste Pipe?
 

On Sep 22, 9:13*pm, Josh wrote:
I'm replacing my old kitchen sink and all the plumbing underneath it.
I'll probably use all plastic/PVC for the drain pipes. *Anyway,
everything has gone reasonably well until I tried to unscrew the metal
waste pipe that runs from the trap to the main sewer pipe in the
wall. *I'm sure it's been in there since the house was built in 1959
and I can't get it to budge, even with a 24" pipe wrench.

This particular one looks like very tarnished copper, about 7" long
and 1 1/2" in diameter. *It appears to be sweat soldered on to a 2"
bushing or threaded male adapter, which is threaded into the main pipe
in the wall. *They used a lot of pipe joint compound on the threads,
and it's hardened. *I've squirted Liquid wrench on in 3 times, but
since it's running horizontially I don't think it's penetrating very
far.

Any of you professional or experienced amateur plumbers got any tips
on how to deal with it?

I've been using the pipe wrench near the trap, so I won't accidentally
damage the new hot & cold water plumbing. *Also, I've got more room to
work out there. *Would I be able to apply more torque closer to the
wall (connection)? *Not as much room to work close to the wall,
because of the other plumbing.

Getting the closer to the wall won't give you more torque but there
will be less moment tending the tear the threads out of the wall
fitting so closer is better in that regard.

How big is the wrench you're using? Try a bigger wrench (like 18" or
bigger) and TIGHTEN the joint (just a bit of movement) before
attempting to loosen it.......works every time!

cheers
Bob

Tips on Unscrewing Kitchen Sink Waste Pipe?
 

I've seen internal pipe wrenches for smaller pipes. Be nice
if he could get internal pipe wrench, and then impact wrench
to rattle it loose.

The sawzall and cuplr idea is a good one, too.

--
Christopher A. Young
Learn more about Jesus
www.lds.org
..


"fftt" wrote in message
...

Any of you professional or experienced amateur plumbers
got any tips
on how to deal with it?

I've been using the pipe wrench near the trap, so I won't
accidentally
damage the new hot & cold water plumbing. Also, I've got
more room to
work out there. Would I be able to apply more torque
closer to the
wall (connection)? Not as much room to work close to the
wall,
because of the other plumbing.

Getting the closer to the wall won't give you more torque
but there
will be less moment tending the tear the threads out of the
wall
fitting so closer is better in that regard.

How big is the wrench you're using? Try a bigger wrench
(like 18" or
bigger) and TIGHTEN the joint (just a bit of movement)
before
attempting to loosen it.......works every time!

cheers
Bob o
e