Home Repair (alt.home.repair) For all homeowners and DIYers with many experienced tradesmen. Solve your toughest home fix-it problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to alt.home.repair
KD KD is offline
external usenet poster
 
Posts: 30
Default Disconnecting a washing machine

G'day folks:

Just a quick question - how easy is it to disconnect a washer? My new
one is being delivered on the weekend, and they'll install the new
one, take the old one away - as long as it's been disconnected.

Is this a DIY job for someone without much knowledge?

Thanks,

KD
  #2   Report Post  
Posted to alt.home.repair
external usenet poster
 
Posts: 156
Default Disconnecting a washing machine


"KD" wrote in message
...
G'day folks:

Just a quick question - how easy is it to disconnect a washer? My new
one is being delivered on the weekend, and they'll install the new
one, take the old one away - as long as it's been disconnected.

Is this a DIY job for someone without much knowledge?

Thanks,

KD


Yes, no, definitely, maybe, and it all depends.

If your hoses are in good shape, the faucet they tie into is in good shape,
they SHOULD come right off with a pair of channel locks. The drain is a
slip in thing, sometimes having a safety wire or zip tie to keep it from
falling out of the receptacle when a blast of water hits it. The electrical
cord comes right out.

TURN THE WATER OFF AT THE VALVES AT THE END OF THE HOSES. Some washers
have a simple lever that turns both hot and cold off together. Some faucets
are cranky, old, corroded, or all these. The worst case scenario is that
you have trouble with the valves. Disconnect the hoses from the washing
machine, and don't mess with the hose ends on the faucet except to check for
tightness.

Check the nut on the stem of the valve to make sure it is SNUG, NOT TIGHT.
Don't crank down the valves hard, just enough to shut off the water. Watch
for leaks, both when you have the hoses off, and after hooking up the new
one.

Use a bucket to catch what is in the hoses. Make sure if there are any
screens in there that can be taken out and cleaned you do so.

Use this opportunity to switch to braided hoses if not already on there. If
you have to cheap it out, at least change the rubber washers while it's all
apart.

You can do it, just go slow and watch the valves. If you see a lot of
corrosion and crud, you may have problems. If they're relatively clean, it
should be no problem.

I hate that word .................. should.

Good luck.

Steve


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
washing machine [email protected] Home Repair 0 January 9th 07 07:24 PM
Which Washing Machine ?? Tim.. UK diy 42 August 25th 06 07:46 PM
Help with disconnecting a washing machine mollymoonbeam UK diy 12 February 14th 06 10:55 AM
How big should washing machine be? [email protected] Home Ownership 3 October 5th 05 03:29 AM
Washing machine not washing Carl Home Repair 2 March 6th 04 06:32 PM


All times are GMT +1. The time now is 08:58 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"