Hello. I just painted out bathroom cabinents with a semi gloss paint. They
were white oak and looking bad but they took the paint really nice and look
very good. In a couple of spots I put the paint on too heavy and there are
a few runs. What is the best way to remove those runs? I was thinking of
waiting until the paint was 100 percent dry and then using a fine grit
sandpaper to sand them out and then repainting. Is that the way to do it?
Any help is appreciated. Thanks.

Tom

Like you said, wait until absolutely dry and then sand them and touch up if
necessary.


"Cobalt1254" wrote in message
t...
Hello. I just painted out bathroom cabinents with a semi gloss paint.
They were white oak and looking bad but they took the paint really nice
and look very good. In a couple of spots I put the paint on too heavy and
there are a few runs. What is the best way to remove those runs? I was
thinking of waiting until the paint was 100 percent dry and then using a
fine grit sandpaper to sand them out and then repainting. Is that the way
to do it? Any help is appreciated. Thanks.

Tom

Cobalt1254 wrote:
Hello. I just painted out bathroom cabinents with a semi gloss paint. They
were white oak and looking bad but they took the paint really nice and look
very good. In a couple of spots I put the paint on too heavy and there are
a few runs. What is the best way to remove those runs? I was thinking of
waiting until the paint was 100 percent dry and then using a fine grit
sandpaper to sand them out and then repainting. Is that the way to do it?
Any help is appreciated. Thanks.

Tom


I would use a new razor blade scraper to shave them off when the paint
is cured. Then sand and put one thin coat on the panel that has the
globbies.

Helps when painting vertical surface to brush paint on across the grain
to cover and then run the brush down straight and lightly, top to
bottom. It also helps to keep a small foam brush with mineral spirits
to touch those little drips or pick out a dust particle that shows.

On Wed, 30 May 2007 17:45:40 -0700, "Cobalt1254"
wrote:

Hello. I just painted out bathroom cabinents with a semi gloss paint. They
were white oak and looking bad but they took the paint really nice and look
very good. In a couple of spots I put the paint on too heavy and there are
a few runs. What is the best way to remove those runs? I was thinking of
waiting until the paint was 100 percent dry and then using a fine grit
sandpaper to sand them out and then repainting. Is that the way to do it?
Any help is appreciated. Thanks.

Tom



Yes. When painting cabinet doors, remove the door, place it flat,
then paint--no runs.