How do I convert this 220v outlet
 

I have a device that requires a 220v 20amp outlet. The male plug on
this is like:

- |
o

I have a 220v 40amp recepticle on the wall which is like:

u
| o |
_
|

On the plug I assume the two prongs are both hots and the round prong
is the saftey ground with no neutral on the plug.

On my recepticle are the two straight slots the hots, the u the saftey
ground and the upside down L the neutral?

I can't remove this outlet and my concern is to not mix up the ground
and the neutral.

I'm not going to replace the outlet. I just want to make a little
extension cord adapter.

How do I convert this 220v outlet
 

In article . com, wrote:
I have a device that requires a 220v 20amp outlet. The male plug on
this is like:

- |
o

I have a 220v 40amp recepticle on the wall which is like:

u
| o |
_
|

You sure that's 40A? Looks like a 30A configuration to me...

Go to this page
http://frentzandsons.com/Hardware%20...leconfiguratio.
htm

and verify that what you have is a NEMA 6-20P plug and a NEMA 14-30R
receptacle.

IF that's the case, then...

On the plug I assume the two prongs are both hots and the round prong
is the saftey ground with no neutral on the plug.

... correct

On my recepticle are the two straight slots the hots, the u the saftey
ground and the upside down L the neutral?

... correct.

I can't remove this outlet and my concern is to not mix up the ground
and the neutral.

I'm not going to replace the outlet. I just want to make a little
extension cord adapter.

Sounds good to me -- assuming that you have what I think you have.

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.

How do I convert this 220v outlet
 

On Feb 27, 11:44 am, (Doug Miller) wrote:
In article . com, wrote:
I have a device that requires a 220v 20amp outlet. The male plug on
this is like:

- |
o

I have a 220v 40amp recepticle on the wall which is like:

u
| o |
_
|

You sure that's 40A? Looks like a 30A configuration to me...

Go to this pagehttp://frentzandsons.com/Hardware%20References/plugandreceptacleconfi....
htm

and verify that what you have is a NEMA 6-20P plug and a NEMA 14-30R
receptacle.

IF that's the case, then...

On the plug I assume the two prongs are both hots and the round prong
is the saftey ground with no neutral on the plug.

.. correct



On my recepticle are the two straight slots the hots, the u the saftey
ground and the upside down L the neutral?

.. correct.



I can't remove this outlet and my concern is to not mix up the ground
and the neutral.

I'm not going to replace the outlet. I just want to make a little
extension cord adapter.

Sounds good to me -- assuming that you have what I think you have.

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.

You might be right, I thought it was hooked up to two 20 amp breakers
but maybe they are 15A breakers. Especially since I don't see any 40A
rated outlets on the site. Nice site (although I found the correct
url at: http://www.frentzandsons.com/Hardwar...onsHdweRef.htm)

How do I convert this 220v outlet