Gas Furnace Works Only When Power Reset
Hello,
My gas furnace turns on if I reset the power to it and brings the temperature up to set point. However, it seems that the next time the thermostat sends the signal, the furnace doesn't start until I cycle its power switch. Please advise. Thank you, Sam |
Gas Furnace Works Only When Power Reset
That's the furnace's way of telling you that it has a problem. You need to
call someone who can diagnose and repair the problem "Sam" wrote in message oups.com... Hello, My gas furnace turns on if I reset the power to it and brings the temperature up to set point. However, it seems that the next time the thermostat sends the signal, the furnace doesn't start until I cycle its power switch. Please advise. Thank you, Sam |
Gas Furnace Works Only When Power Reset
On 14 Jan 2007 06:18:17 -0800, "Sam" wrote:
Hello, My gas furnace turns on if I reset the power to it and brings the temperature up to set point. However, it seems that the next time the thermostat sends the signal, the furnace doesn't start until I cycle its power switch. There is no way to troubleshoot a furnace remotely But it sounds as though it is locking out on a flame safety. You should have it checked before it locks out permanently. |
Gas Furnace Works Only When Power Reset
I agree,have it checked or replaced..You can ask here too for advice or
confirmation.. http://www.hvacmechanic.com/forums/forums.htm HVACTECH2 wrote: On 14 Jan 2007 06:18:17 -0800, "Sam" wrote: Hello, My gas furnace turns on if I reset the power to it and brings the temperature up to set point. However, it seems that the next time the thermostat sends the signal, the furnace doesn't start until I cycle its power switch. There is no way to troubleshoot a furnace remotely But it sounds as though it is locking out on a flame safety. You should have it checked before it locks out permanently. |
Gas Furnace Works Only When Power Reset
On 14 Jan 2007 06:18:17 -0800, "Sam" wrote:
Hello, My gas furnace turns on if I reset the power to it and brings the temperature up to set point. However, it seems that the next time the thermostat sends the signal, the furnace doesn't start until I cycle its power switch. Please advise. Thank you, Sam What senses the presence of the flame? Heat sensor- adjust, clean or replace.... Light sensor - clean or replace |
Gas Furnace Works Only When Power Reset
|
All times are GMT +1. The time now is 05:54 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter