Terminating wallpaper edge
 

The masochists who owned this house before me put wallpaper in the bathroom,
including the bathtub walls. There's a very effective fan in the bathroom,
but that doesn't matter. The wallpaper in the tub area still gets wet, and
is a pain to maintain. Just outside the curtain rod, there's a seam in a
perfect spot to terminate the wallpaper and strip inward to remove what's in
the tub area. But, I'm concerned about leaving an exposed edge that close to
the source of moisture. Anyone seen any creative ideas for covering such an
edge?

Terminating wallpaper edge
 

A straight piece of clear plastic or opaque with silicone seal under
it.
A couple of stanless screws so you also have a mechanical bond.
Look at the clear corner protectors that go on an outside corner,
perhaps split one.
JoeSpareBedroom wrote:
The masochists who owned this house before me put wallpaper in the bathroom,
including the bathtub walls. There's a very effective fan in the bathroom,
but that doesn't matter. The wallpaper in the tub area still gets wet, and
is a pain to maintain. Just outside the curtain rod, there's a seam in a
perfect spot to terminate the wallpaper and strip inward to remove what's in
the tub area. But, I'm concerned about leaving an exposed edge that close to
the source of moisture. Anyone seen any creative ideas for covering such an
edge?

Terminating wallpaper edge
 

Paint with clear finger nail polish might seal well enough.

"JoeSpareBedroom" wrote in message
...
The masochists who owned this house before me put wallpaper in the
bathroom, including the bathtub walls. There's a very effective fan in the
bathroom, but that doesn't matter. The wallpaper in the tub area still
gets wet, and is a pain to maintain. Just outside the curtain rod, there's
a seam in a perfect spot to terminate the wallpaper and strip inward to
remove what's in the tub area. But, I'm concerned about leaving an exposed
edge that close to the source of moisture. Anyone seen any creative ideas
for covering such an edge?

Terminating wallpaper edge
 

JoeSpareBedroom wrote:
The masochists who owned this house before me put wallpaper in the bathroom,
including the bathtub walls. There's a very effective fan in the bathroom,
but that doesn't matter. The wallpaper in the tub area still gets wet, and
is a pain to maintain. Just outside the curtain rod, there's a seam in a
perfect spot to terminate the wallpaper and strip inward to remove what's in
the tub area. But, I'm concerned about leaving an exposed edge that close to
the source of moisture. Anyone seen any creative ideas for covering such an
edge?

I have wallpaper up to edge of shower stall opening. When I repapered
that bath, I masked off a line along both edges at entry to shower.
Masked off a line same width as tile grout lines, run fine bead of
white caulk, take off masking tape, smoothe the edge. Doesn't have to
be thick to seal the edge. Also did the same along the other edges and
bottom of wallpaper; have tile "baseboards", so white worked there as
well. O'wise I would use clear along the bottom.

We also put a timer switch on the vent fan so the bathroom gets
decently dry; set for 30 min usually.

Now I have to attack - again - the two rusty nailheads that keep
peeking through the paint of the ceiling of the shower enclosure.
Thought I had them licked a year ago :o)

Terminating wallpaper edge
 

In article .com, "NorMinn" wrote:

Now I have to attack - again - the two rusty nailheads that keep
peeking through the paint of the ceiling of the shower enclosure.
Thought I had them licked a year ago :o)

Next time, paint them instead of licking them. g

Seriously, did you use an oil-based paint last time, or at least an oil-based
primer?

--
Regards,
Doug Miller (alphageek at milmac dot com)

It's time to throw all their damned tea in the harbor again.

Terminating wallpaper edge
 

"NorMinn" wrote in message
oups.com...

JoeSpareBedroom wrote:
The masochists who owned this house before me put wallpaper in the
bathroom,
including the bathtub walls. There's a very effective fan in the
bathroom,
but that doesn't matter. The wallpaper in the tub area still gets wet,
and
is a pain to maintain. Just outside the curtain rod, there's a seam in a
perfect spot to terminate the wallpaper and strip inward to remove what's
in
the tub area. But, I'm concerned about leaving an exposed edge that close
to
the source of moisture. Anyone seen any creative ideas for covering such
an
edge?

I have wallpaper up to edge of shower stall opening. When I repapered
that bath, I masked off a line along both edges at entry to shower.
Masked off a line same width as tile grout lines, run fine bead of
white caulk, take off masking tape, smoothe the edge. Doesn't have to
be thick to seal the edge. Also did the same along the other edges and
bottom of wallpaper; have tile "baseboards", so white worked there as
well. O'wise I would use clear along the bottom.

We also put a timer switch on the vent fan so the bathroom gets
decently dry; set for 30 min usually.

Now I have to attack - again - the two rusty nailheads that keep
peeking through the paint of the ceiling of the shower enclosure.
Thought I had them licked a year ago :o)


Good idea. As far as the fan, I've thought of putting a motion detector in
the bath zone. Or, make my son spend some time cleaning off the mildew,
which might be another way of making sure the fan goes on when he showers.
:-)