recessed lighting
 

greetings, i will be building a soffit? over a kitchen island and i have
a few questions. first of all i bought a six pack of lighting cans from
home depot (halo brand) and i got the type that can be touching
insulation. their will be no insulation in the soffit so is it okay to
still use there lights or should i get the no insulation type? also,
what would be the recommended distance between the top of the can and
the ceiling above? the soffit will be constructed on the floor and then
attached to the ceiling that has drywall. should i be concerned about
heat build-up? i am planning on using three lights spaced evenly in a 7
foot long rectangular soffit. i also would like to have the lights
hooked up to a dimmer switch.
thanks for any tips, input and advice
cj

recessed lighting
 

"cj" wrote in message
...
greetings, i will be building a soffit? over a kitchen island and i have
a few questions. first of all i bought a six pack of lighting cans from
home depot (halo brand) and i got the type that can be touching
insulation. their will be no insulation in the soffit so is it okay to
still use there lights or should i get the no insulation type? also,
what would be the recommended distance between the top of the can and
the ceiling above? the soffit will be constructed on the floor and then
attached to the ceiling that has drywall. should i be concerned about
heat build-up? i am planning on using three lights spaced evenly in a 7
foot long rectangular soffit. i also would like to have the lights
hooked up to a dimmer switch.
thanks for any tips, input and advice
cj

Personally I will not install the non insulation rated fixtures. Since you
bought fixtures the can to be in contact with insulation you have no worries
about clearances to the drywall.
The IC rated fixtures have a thermal switch in them. When they get to hot
they shut off, which freaks out people when the lights are "twinkling" cause
they decided to install larger bulbs than recommended by the manufacture.

recessed lighting
 

It all depends upon which trim you'd like to use. IC, non IC, ICAT, etc all
use specific trims. All of these frame in kits use thermal protectors which
shut off power if the units overheat. I don't believe there is a minimum
distance to the framing above the fixture, but I believe they must be one
inch away from framing on the sides

"cj" wrote in message
...
greetings, i will be building a soffit? over a kitchen island and i have a
few questions. first of all i bought a six pack of lighting cans from home
depot (halo brand) and i got the type that can be touching insulation.
their will be no insulation in the soffit so is it okay to still use there
lights or should i get the no insulation type? also, what would be the
recommended distance between the top of the can and the ceiling above? the
soffit will be constructed on the floor and then attached to the ceiling
that has drywall. should i be concerned about heat build-up? i am planning
on using three lights spaced evenly in a 7 foot long rectangular soffit. i
also would like to have the lights hooked up to a dimmer switch.
thanks for any tips, input and advice
cj