Door knob problem
 

Take a business card, and cut a strip about 3/8 inch wide. Put that into the
knob hole, and then thread the knob on. Tighten with screw. Rip the last of
the cardboard off.

works for awhile. Thats' what I do.

--

Christopher A. Young
Do good work.
It's longer in the short run
but shorter in the long run.
..
..


wrote in message
...
Our home is approx. 120 years old and has nine doors using the glass
doorknobs with threaded spindles. The problem is that with time, the
knobs pull off the spindle and no amount of resetting and tightening
the set screw on the knob will keep them in place for longer than a
week or so.

At one point I wrapped a few rounds of teflon plumbers' tape around
the spindle thinking that it might increase the diameter enough to
create a better hold. This lasted a few weeks longer than usual but
eventually the knob pulled off the spindle.

I'm tempted to wrap some epoxy resin putty around the spindles for a
permanent solution but shudder at the thought of ever having to
replace them. Does anyone have a better solution?