How to store electric pressure washer????
 

Here's the directions for a gasoline job.
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump. This
prevents freeze damage and lubricates pistons and seals.

SNIPPED FOR BREVITYNOTE:

If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.

____Reply Separator_____

OK, how do you turn an electric model over about two revolutions???

OK, how do you turn an electric model over about two revolutions???

Plug it in briefly.

you could probably also get away with a few drops of air tool lubricating
oil (or any lightweight lube) as long as you were sure it got in contact
with the moving piston and displaced any plain water. take the hose off,
tip the unit on its side so that the opening is upright and drip a
tablespoons worth right inside the hole. essentially the same maintenence
as a power painter just harder to get at both sides of the pump.

The obvious drawback is that you might have a little oil residue on the
first thing you wash. once the detergent gets flowing, it will clean itself
right out.


"John Harlow" wrote in message
...

OK, how do you turn an electric model over about two revolutions???

Plug it in briefly.

My Karcher electric just says to run out water for 2 seconds and keep
from freezing. Freezing is the killer.

I also keep the hose valve open and make sure all water drains from the
unattached hose as I wind it up for storage.


"m Ransley" wrote in message
...
My Karcher electric just says to run out water for 2 seconds and keep
from freezing. Freezing is the killer.