Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 172
Default Panasonic DMR-ES20 DVD Recorder Issue

Hi,

I have a Panasonic DVD recorder issue. When you plug it in (AC outlet),
the rolling "ooooooo" (initializing/recovery) never ends. I can force it to
go into standby by holding the Power button (on front panel) for 10 seconds.
Now there is a flashing "12:00". Next, I press the power button on unit or
remote, and a "Hello" appears. Normally, the "Hello" appears for a few
seconds, then goes away. Now, "Hello" stays on for hours. I did not wait to
see how many hours. Note: If I hold the power button for 10 seconds on the
unit, the display changes back to the flashing "12:00". However, I still can
NOT use this recorder.

PLEASE do NOT make suggestions because I have been there and
done that (years of electronics service repair background).

IMPORTANT:

I am looking for someone who had the EXACT SAME problem with
this model, "DMR-ES20" (NO letters after "20"), and he/she fixed
it. What did you do to fix this problem?

Thank You in advance, John


  #2   Report Post  
Posted to sci.electronics.repair
Lee Lee is offline
external usenet poster
 
Posts: 698
Default Panasonic DMR-ES20 DVD Recorder Issue

Yes. Bad capacitor. Replacing it fixed it.
  #4   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 73
Default Panasonic DMR-ES20 DVD Recorder Issue

Once upon a time on usenet Lee wrote:
Yes. Bad capacitor. Replacing it fixed it.


Handy to know. I have a DMR-ES20 that I haven't used for a few years but I
did like it a lot and you never know...
--
Shaun.

"Humans will have advanced a long, long way when religious belief has a cozy
little classification in the DSM*."
David Melville (in r.a.s.f1)
(*Diagnostic and Statistical Manual of Mental Disorders)


  #5   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 10
Default Panasonic DMR-ES20 DVD Recorder Issue

On Fri, 13 Jul 2018, ~misfit~ wrote:

Once upon a time on usenet Lee wrote:
Yes. Bad capacitor. Replacing it fixed it.


Handy to know. I have a DMR-ES20 that I haven't used for a few years but I
did like it a lot and you never know...


I had some other DVD recorder, I found it in a recycling bin. It worked,
but got flakier. It used a standard 40pin connector, so I tried a
computer DVD drive, I think that worked, but didn't fix the problem.

So yes, given that I got an Acer 19" LCD monitor going by changing
electrolytics in the power supply (it sort of worked, but would reset and
I'd lose video then), I'm inclined to believe the DVD recorder needs new
electrolytics in the power supply. I've yet to pursue it because it's not
very useful now, the tuner doesn't receive DTV. But if it was still
useful, I'd have pursued the power supply.

Michael



  #6   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 1,212
Default Panasonic DMR-ES20 DVD Recorder Issue

On 12/07/18 16:03, wrote:
Hi,

I have a Panasonic DVD recorder issue. When you plug it in (AC outlet),
the rolling "ooooooo" (initializing/recovery) never ends. I can force it to
go into standby by holding the Power button (on front panel) for 10 seconds.
Now there is a flashing "12:00". Next, I press the power button on unit or
remote, and a "Hello" appears. Normally, the "Hello" appears for a few
seconds, then goes away. Now, "Hello" stays on for hours. I did not wait to
see how many hours. Note: If I hold the power button for 10 seconds on the
unit, the display changes back to the flashing "12:00". However, I still can
NOT use this recorder.

PLEASE do NOT make suggestions because I have been there and
done that (years of electronics service repair background).

IMPORTANT:

I am looking for someone who had the EXACT SAME problem with
this model, "DMR-ES20" (NO letters after "20"), and he/she fixed
it. What did you do to fix this problem?

Thank You in advance, John


Many years ago I had a somewhat similar problem with a similar Panasonic
DVD recorder (DMR-E55). It went into an endless checking cycle at switch
on. It was fixed by replacing the regulator chip (Sanken STRG6353),
which was stressed and operating at the limit of its specs with a
barely-sufficient heat sink. I also fitted a bigger heat sink.

Why might this be relevant despite your comment? Because the same fault
was known to affect other Panasonic DVD and HDD devices.

--

Jeff
  #8   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 1,630
Default Panasonic DMR-ES20 DVD Recorder Issue

" I am looking for someone who had the EXACT SAME problem with
this model, "DMR-ES20" (NO letters after "20"), and he/she fixed
it. What did you do to fix this problem? "

How many people do you think are on Usenet ? You think this is Facebook ?

Don't want to troubleshoot ? Join Repairworld.
  #11   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 73
Default Panasonic DMR-ES20 DVD Recorder Issue

Once upon a time on usenet Michael Black wrote:
On Fri, 13 Jul 2018, ~misfit~ wrote:

Once upon a time on usenet Lee wrote:
Yes. Bad capacitor. Replacing it fixed it.


Handy to know. I have a DMR-ES20 that I haven't used for a few years
but I did like it a lot and you never know...


I had some other DVD recorder, I found it in a recycling bin. It
worked, but got flakier. It used a standard 40pin connector, so I
tried a computer DVD drive, I think that worked, but didn't fix the
problem.
So yes, given that I got an Acer 19" LCD monitor going by changing
electrolytics in the power supply (it sort of worked, but would reset
and I'd lose video then), I'm inclined to believe the DVD recorder
needs new electrolytics in the power supply. I've yet to pursue it
because it's not very useful now, the tuner doesn't receive DTV. But
if it was still useful, I'd have pursued the power supply.


I really liked the way mine handled DVD-RAM. Being able to chase-record
(time-slip) with a DVD recorder was great, as was being able to part-erase a
disc.
--
Shaun.

"Humans will have advanced a long, long way when religious belief has a cozy
little classification in the DSM*."
David Melville (in r.a.s.f1)
(*Diagnostic and Statistical Manual of Mental Disorders)


  #12   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 6
Default Panasonic DMR-ES20 DVD Recorder Issue

Adrian Caspersz wrote:


All of them done without component diagnosis?


I have an DMR-E30 with an issue very equal. You can switch it on and
nothing happens. It looks dead. But wenn you switch it of (10s
keypress) it write "BYE" in the Display. All Powerrails are fine.

I have a servicemanual and I know there is a maintanance mode. But it
did not work. So I realy believe there is something wrong in the
mainprocessor, because it can write "BYE" in the VFD, but it did not
change its behavier with maintanance jumper. Strange!

Sounds like a processor code crash. Noisy power rails. Bad supply
decoupling.


The old Panis are famous for a fault in the supply, especially of the
chip someone wrote before in this thread. Unfortunatly some have
bigger problems.

That is very sad, because the human interface device was much more
sophisticated than on my new 2000Euro TV with integrated recording
cabability. But fortunatly the TV program is so bad in these days that
recording is not necessary anymore.

Olaf

  #13   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 6
Default Panasonic DMR-ES20 DVD Recorder Issue

Stephen Wolstenholme wrote:

Many people prefer Usenet to Facebook. Some people don't use Facebook
at all. I'm one of them.


Yes. Facebook is a little corny. Everyone switched to WeChat!

Olaf
  #14   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 57
Default Panasonic DMR-ES20 DVD Recorder Issue

On Fri, 13 Jul 2018 23:32:12 +1200, "~misfit~"
wrote:

Once upon a time on usenet Stephen Wolstenholme wrote:
On Fri, 13 Jul 2018 01:58:19 -0700 (PDT), wrote:

" I am looking for someone who had the EXACT SAME problem with
this model, "DMR-ES20" (NO letters after "20"), and he/she fixed
it. What did you do to fix this problem? "

How many people do you think are on Usenet ? You think this is
Facebook ?

Don't want to troubleshoot ? Join Repairworld.


Many people prefer Usenet to Facebook. Some people don't use Facebook
at all. I'm one of them.


Medal?


I used Facebook when it first started and looked forward to it's
growth. After a few months nobody of interest to me started to use it.
My wife has loads of mystery "friends" on Facebook. She realised a few
weeks ago that they were trying to help sell something that was using
Facebook to market products. She has now been slowly removing people
but finding many become "friends" again. It's not so easy to remove
people using Facebook. She deserved a medal for persistence.

I asked the daughter of one of my staff what she did on Facebook for
hours every day. She mumbled something like "I must because everybody
else is using it".

OTOH the Usenet groups that are being used for marketing are easy to
delete, ignore or filter out.

Steve

I bet you be watch commercial TV channels.

--
http://www.npsnn.com

  #15   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 73
Default Panasonic DMR-ES20 DVD Recorder Issue

Once upon a time on usenet Stephen Wolstenholme wrote:
On Fri, 13 Jul 2018 23:32:12 +1200, "~misfit~"
wrote:

Once upon a time on usenet Stephen Wolstenholme wrote:
On Fri, 13 Jul 2018 01:58:19 -0700 (PDT), wrote:

" I am looking for someone who had the EXACT SAME problem with
this model, "DMR-ES20" (NO letters after "20"), and he/she fixed
it. What did you do to fix this problem? "

How many people do you think are on Usenet ? You think this is
Facebook ?

Don't want to troubleshoot ? Join Repairworld.

Many people prefer Usenet to Facebook. Some people don't use
Facebook at all. I'm one of them.


Medal?


I used Facebook when it first started and looked forward to it's
growth. After a few months nobody of interest to me started to use it.


So when you said "Some people don't use Facebook AT ALL. I'm one of them" it
was a lie. Got it.

My wife has loads of mystery "friends" on Facebook. She realised a few
weeks ago that they were trying to help sell something that was using
Facebook to market products. She has now been slowly removing people
but finding many become "friends" again. It's not so easy to remove
people using Facebook. She deserved a medal for persistence.

I asked the daughter of one of my staff what she did on Facebook for
hours every day. She mumbled something like "I must because everybody
else is using it".

OTOH the Usenet groups that are being used for marketing are easy to
delete, ignore or filter out.

Steve

I bet you be watch commercial TV channels.


I'll double down on that bet.
--
Shaun.

"Humans will have advanced a long, long way when religious belief has a cozy
little classification in the DSM*."
David Melville (in r.a.s.f1)
(*Diagnostic and Statistical Manual of Mental Disorders)




  #16   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 172
Default Panasonic DMR-ES20 DVD Recorder Issue

On Thu, 12 Jul 2018 17:56:21 +0100, Lee wrote:

Yes. Bad capacitor. Replacing it fixed it.


There is more than one capacitor in this unit.

WHICH CAPCACITOR?

John

  #17   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 1
Default Panasonic DMR-ES20 DVD Recorder Issue

Hello
I would like to help owners of DMR-ES20 to fix the known "zero" error.
This occur due a failure on PSU section that can't provide correct voltages to other sections/modules.
Is recommended replace 7 electrolytic capacitors (a cap kit) with 105°C range.

C1143 100uF 350V
C1150 56uF 35V
C1280 680uF 10V
C1400 470uf 16V
C1270 1000uf 16V
C1260 1500uF 10V
C1281 47uF 25V
Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Panasonic DVD Recorder DMR-ES20 Long Time to Initialize [email protected] Electronics Repair 4 February 2nd 17 01:52 AM
Panasonic DVD Recorder DMR-ES20 takes Long Time to Initialize [email protected] Electronics Repair 17 February 1st 17 07:47 PM
Panasonic DVD player model: DMR-E80H [email protected] Electronics Repair 0 October 9th 08 07:24 PM
How to view the firmware version: Panasonic DMR-ES20 DVD burner? Gene Electronics Repair 6 January 18th 07 11:54 PM
DVD Recorder Disks Types (DVD-R, DVD+R, DVD-RAM, etc.) Brad Electronics Repair 1 October 27th 05 03:21 PM


All times are GMT +1. The time now is 06:31 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"