How to tighten round nut on swtich?
micky wrote on 10/25/2017 9:15 PM:
I need to put a momentary on switch in my dashboard, and the one I bought doesn't have a hex nut for the top nut but a round serrated ring to hold the switch in place. How do you tighten this? I don't see how fingers can do as good a job as a wrench did with the hex nut, and pliers will scratch it up. I could find an old hex nut, but I'd rather use the pretty round one, if I can. Use some cloth to cover the nut and then use pliers. Just don't grip too tightly or it can tear through the cloth. -- Rick C Viewed the eclipse at Wintercrest Farms, on the centerline of totality since 1998 |
How to tighten round nut on swtich?
In sci.electronics.repair, on Wed, 25 Oct 2017 21:26:58 -0400, rickman
wrote: micky wrote on 10/25/2017 9:15 PM: I need to put a momentary on switch in my dashboard, and the one I bought doesn't have a hex nut for the top nut but a round serrated ring to hold the switch in place. How do you tighten this? I don't see how fingers can do as good a job as a wrench did with the hex nut, and pliers will scratch it up. I could find an old hex nut, but I'd rather use the pretty round one, if I can. Use some cloth to cover the nut and then use pliers. Just don't grip too tightly or it can tear through the cloth. Okay, I'll do that. Maybe I can just hold the nut that way and turn the hex nut behind the dash next to the box below the radio and above the consoleradio. In this case, I'll have access to it. It's interesting to learn, Tom, that there is a special tool Thanks all. |
All times are GMT +1. The time now is 03:35 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter