RCA 35" - F35050ST - CTC169BE2 Chassis - Slow Vertical Deflection.
There is a part(s) that is changing its performance with heat. Most likely
it is a bad cap in the vertical deflection area. You would have to troubleshoot the set for this. Don't use the set this way. It is best to fix it, because if it fails, it can cause other damage that will be more involved and costly to service. -- Jerry G. ===== "dressden" wrote in message om... Gurus, thanks in advance. This TV has a strange symptom. When powered on, the relay clicks and the HV comes on with no vertical deflection or a very little vertical deflection bowed towards the bottom. However, after 5-7 minutes after the set warms up, the vertical deflection comes on and the tv works properly for a long time. I understand that the vertical defection is switched off until the deguassing is complete on this model. However I cannot figure out where to look for the fault, - Vertical or Degaussing or Power supply. Has anyone seen this problem and could anyone point me to the section to check. Thanks |
All times are GMT +1. The time now is 07:27 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter