rf modulator problem
 

I am trying to run video from a computer video card to an older TV
with a coax cable input only. I am using a composite video cable to
an RF modulator box, then to the TV with the coax. The picture has
lines and is jumpy like the frequency is slightly off. There isn't an
obvious fine tuning adjustment on the tv. I was wondering if its
possible to adjust it, or if theres anything else that could be
causing the problem. Its a zenith, about 10 years old. It works fine
for normal viewing.

any help is appreciated. thanks

Aron

rf modulator problem
 

Aron:

The very first obvious question that I have is:

Does the video signal from the computer video card through the RF modulator
box work OK with a different television??
--
Best Regards,
Daniel Sofie
Electronics Supply & Repair
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -


"Aron" wrote in message
om...
I am trying to run video from a computer video card to an older TV
with a coax cable input only. I am using a composite video cable to
an RF modulator box, then to the TV with the coax. The picture has
lines and is jumpy like the frequency is slightly off. There isn't an
obvious fine tuning adjustment on the tv. I was wondering if its
possible to adjust it, or if theres anything else that could be
causing the problem. Its a zenith, about 10 years old. It works fine
for normal viewing.

any help is appreciated. thanks

Aron