Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Sony CPD-520GS compass module wanted or a IC on it. (SIU-212)
Do you still need this part?
If so, e-mail back to bobkos at earthlink dot net. You know what to change... "Jason D." wrote in message ... The monitor came in with purity complaint and found remains of liquid spill made a direct bulleye hit on that tiny standoff board of this L2 board. This L2 board on four plastic standoffs right smackdab in middle of chassis under yoke. This monitor depends on it to preset part of convergence & purity areas when monitor is in different directions. Wanted either: The small module is SIU-212, (Location GS001 on L2 board) with two X & Y coils goes onto the purity board (retangular shaped L2 board is p/n 1-670-493-11). Or this IC either location: IC1 or IC5001, IC itself is A2538N, one leg corroded off right at IC's body. Cheers, Wizard |
#2
|
|||
|
|||
Sony CPD-520GS compass module wanted or a IC on it. (SIU-212)
almost sounded like a bad microprocessor to me, but im not the camera expert
by far. wolf "Bob Kos" wrote in message hlink.net... Do you still need this part? If so, e-mail back to bobkos at earthlink dot net. You know what to change... "Jason D." wrote in message ... The monitor came in with purity complaint and found remains of liquid spill made a direct bulleye hit on that tiny standoff board of this L2 board. This L2 board on four plastic standoffs right smackdab in middle of chassis under yoke. This monitor depends on it to preset part of convergence & purity areas when monitor is in different directions. Wanted either: The small module is SIU-212, (Location GS001 on L2 board) with two X & Y coils goes onto the purity board (retangular shaped L2 board is p/n 1-670-493-11). Or this IC either location: IC1 or IC5001, IC itself is A2538N, one leg corroded off right at IC's body. Cheers, Wizard |
#3
|
|||
|
|||
Sony CPD-520GS compass module wanted or a IC on it. (SIU-212)
On Sat, 06 Mar 2004 05:06:24 GMT, "wolfhedd"
wrote: almost sounded like a bad microprocessor to me, but im not the camera expert by far. wolf I actually identified that module correctly, it WAS compass module. The monitor compensates for different directions the monitor is turned on it's base. Monitor still works before and after but needs this module to adjust purity basing on compass's data. Hence the small standoff module is in close center where base Z axis is. L2 board that hosts the compass module is a convergence & purity ampifiers board. Fixed as posted in updated post everywhere else. Cheers, Wizard "Bob Kos" wrote in message thlink.net... Do you still need this part? If so, e-mail back to bobkos at earthlink dot net. You know what to change... |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
FIXED: Sony CPD-520GS compass module | Electronics Repair | |||
Wanted Schematic and Exploded View Of SONY CCD-F201 Camcorder Video 8 | Electronics Repair | |||
Sony KV-32XBR10 TV Module Protector & Horizontal Coil | Electronics Repair |