Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Pioneer SD-P5047Q Convergence
I have a Pioneer SD-P5047Q rear projection 52" television. The Convergence
goes out from time to time and the adjustment settings on the set will not allow you to correct it completely. After a few days of messing with it, it will usually flip to the other side and the adjustment will allow you to fix it. It happens about once a week now and lasts a few days. My question is: What can be done to fix this so it will not go out as often? And/Or what parts need to be replaced? Is the television worth repairing or should I replace it with a new television? Any help would be greatly appreciated. Brian |
#2
|
|||
|
|||
Pioneer SD-P5047Q Convergence
Brian Foster wrote:
I have a Pioneer SD-P5047Q rear projection 52" television. The Convergence goes out from time to time and the adjustment settings on the set will not allow you to correct it completely. After a few days of messing with it, it will usually flip to the other side and the adjustment will allow you to fix it. It happens about once a week now and lasts a few days. My question is: What can be done to fix this so it will not go out as often? And/Or what parts need to be replaced? Is the television worth repairing or should I replace it with a new television? Any help would be greatly appreciated. Brian All of the Pioneer projection TVs I've seen have had lots of bad soldering on the main board and convergence board. If you haven't, go over the boards very carefully and resolder any questionable connections. If that doesn't fix it and it uses several large power ICs with a number starting with STK, one of them is probably bad. To confirm this, you could swap them around if there are more than one of the sape type. -- Andy Cuffe |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mits VS60601 convergence | Electronics Repair | |||
Sony KP-61XBR200 convergence ideas? | Electronics Repair | |||
Need Pioneer Service Remote GGF1381 | Electronics Repair | |||
PTK195 convergence woes, intermittent of course | Electronics Repair |