Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
PCB prototyping idea
I was in a craft shop today and one of these was being demonstrated
www.cricut.com I got the demonstrator to try it out on 0.05mm thick copper foil. It worked very well on parallel lines 0.3mm spacing and letters where the vertical body of letters wer of qwerty were 2mm high and extra curveyness of the "fun" script cut out and came through perfectly well. It would have gone smaller I'm sure but that was the minimum she could go to on her tablet and typeface. She was so impressed she emailed a pic the engineering department of that company. Machine is roller feed of flat sheet. Requires firm , more than stick-it note, bonding of the foil to a backing or the foil will tear. The cutter was not new, a few months of about 22 hours a day use, often left running overnight for multiple outputs, like 3D printer operation. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Prototyping board | UK diy | |||
3-D prototyping printer? | Metalworking | |||
where can I go for prototyping? | Electronics | |||
Prototyping and short run | Metalworking | |||
OT? Rapid Prototyping | Metalworking |