CD Player Display and Button Problem
 

I was wondering if anyone could help diagnose a problem with a Clarion
DRX9255 car cd player. The deck turns on and all the front panel
buttons light, but the display (vacuum fluorescent) is blank. It takes
in a cd and spins it, but there's no signal on the audio outputs. It
also doesn't respond when any of the buttons are pressed, except for
the eject button.. which beeps and ejects the cd when pressed. The
power can still be turned on and off. It's a newer deck, but the face
is non-detachable and it has a true (shaft type) analog volume that's
also the power on/off control.

I tried the microcontroller reset button, and the deck clicks off and
back on, but still the same problem. After reading the repair FAQ and
searching the forums, I'm thinking it could be the microcontroller or
a power supply problem. Does this sound likely, or could it be
something else?

The deck has a large outboard +/-15v DC-DC converter with power and
ground inputs, and then six wires going out to the deck:

In: yellow, black
Out: yellow, black, blue/yellow, black/white, yellow/red, yellow/black

All the connectors and wires test out ok. How should I go about
testing the power supply? From what I can tell, black and black/white
are both grounds, yellow is constant 12v memory to the deck, and
blue/yellow is remote turn-on for the converter. I checked the other
two wires for voltage with the deck on and got nothing on the
yellow/red, and 0.1v on the yellow/black. Also I can hear the
converter "motorboat" or hum quietly when it's on. Is this normal?

Any help or suggestions would be greatly appreciated.

Thanks,
Eric

CD Player Display and Button Problem
 

I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================


"Eric J" wrote in message
om...
I was wondering if anyone could help diagnose a problem with a Clarion
DRX9255 car cd player. The deck turns on and all the front panel
buttons light, but the display (vacuum fluorescent) is blank. It takes
in a cd and spins it, but there's no signal on the audio outputs. It
also doesn't respond when any of the buttons are pressed, except for
the eject button.. which beeps and ejects the cd when pressed. The
power can still be turned on and off. It's a newer deck, but the face
is non-detachable and it has a true (shaft type) analog volume that's
also the power on/off control.

I tried the microcontroller reset button, and the deck clicks off and
back on, but still the same problem. After reading the repair FAQ and
searching the forums, I'm thinking it could be the microcontroller or
a power supply problem. Does this sound likely, or could it be
something else?

The deck has a large outboard +/-15v DC-DC converter with power and
ground inputs, and then six wires going out to the deck:

In: yellow, black
Out: yellow, black, blue/yellow, black/white, yellow/red, yellow/black

All the connectors and wires test out ok. How should I go about
testing the power supply? From what I can tell, black and black/white
are both grounds, yellow is constant 12v memory to the deck, and
blue/yellow is remote turn-on for the converter. I checked the other
two wires for voltage with the deck on and got nothing on the
yellow/red, and 0.1v on the yellow/black. Also I can hear the
converter "motorboat" or hum quietly when it's on. Is this normal?

Any help or suggestions would be greatly appreciated.

Thanks,
Eric

CD Player Display and Button Problem
 

I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================


"Eric J" wrote in message
om...
I was wondering if anyone could help diagnose a problem with a Clarion
DRX9255 car cd player. The deck turns on and all the front panel
buttons light, but the display (vacuum fluorescent) is blank. It takes
in a cd and spins it, but there's no signal on the audio outputs. It
also doesn't respond when any of the buttons are pressed, except for
the eject button.. which beeps and ejects the cd when pressed. The
power can still be turned on and off. It's a newer deck, but the face
is non-detachable and it has a true (shaft type) analog volume that's
also the power on/off control.

I tried the microcontroller reset button, and the deck clicks off and
back on, but still the same problem. After reading the repair FAQ and
searching the forums, I'm thinking it could be the microcontroller or
a power supply problem. Does this sound likely, or could it be
something else?

The deck has a large outboard +/-15v DC-DC converter with power and
ground inputs, and then six wires going out to the deck:

In: yellow, black
Out: yellow, black, blue/yellow, black/white, yellow/red, yellow/black

All the connectors and wires test out ok. How should I go about
testing the power supply? From what I can tell, black and black/white
are both grounds, yellow is constant 12v memory to the deck, and
blue/yellow is remote turn-on for the converter. I checked the other
two wires for voltage with the deck on and got nothing on the
yellow/red, and 0.1v on the yellow/black. Also I can hear the
converter "motorboat" or hum quietly when it's on. Is this normal?

Any help or suggestions would be greatly appreciated.

Thanks,
Eric

CD Player Display and Button Problem
 

"Jerry G." wrote in message ...
I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================


"Eric J" wrote in message
om...
I was wondering if anyone could help diagnose a problem with a Clarion
DRX9255 car cd player. The deck turns on and all the front panel
buttons light, but the display (vacuum fluorescent) is blank. It takes
in a cd and spins it, but there's no signal on the audio outputs. It
also doesn't respond when any of the buttons are pressed, except for
the eject button.. which beeps and ejects the cd when pressed. The
power can still be turned on and off. It's a newer deck, but the face
is non-detachable and it has a true (shaft type) analog volume that's
also the power on/off control.

I tried the microcontroller reset button, and the deck clicks off and
back on, but still the same problem. After reading the repair FAQ and
searching the forums, I'm thinking it could be the microcontroller or
a power supply problem. Does this sound likely, or could it be
something else?

The deck has a large outboard +/-15v DC-DC converter with power and
ground inputs, and then six wires going out to the deck:

In: yellow, black
Out: yellow, black, blue/yellow, black/white, yellow/red, yellow/black

All the connectors and wires test out ok. How should I go about
testing the power supply? From what I can tell, black and black/white
are both grounds, yellow is constant 12v memory to the deck, and
blue/yellow is remote turn-on for the converter. I checked the other
two wires for voltage with the deck on and got nothing on the
yellow/red, and 0.1v on the yellow/black. Also I can hear the
converter "motorboat" or hum quietly when it's on. Is this normal?

Any help or suggestions would be greatly appreciated.

Thanks,
Eric
I have seen quite a few of the flourescent backlights not work in
these units, but test the inverter voltages and the display controller
ic signals with an oscilloscope if you have one.

CD Player Display and Button Problem
 

"Jerry G." wrote in message ...
I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================


"Eric J" wrote in message
om...
I was wondering if anyone could help diagnose a problem with a Clarion
DRX9255 car cd player. The deck turns on and all the front panel
buttons light, but the display (vacuum fluorescent) is blank. It takes
in a cd and spins it, but there's no signal on the audio outputs. It
also doesn't respond when any of the buttons are pressed, except for
the eject button.. which beeps and ejects the cd when pressed. The
power can still be turned on and off. It's a newer deck, but the face
is non-detachable and it has a true (shaft type) analog volume that's
also the power on/off control.

I tried the microcontroller reset button, and the deck clicks off and
back on, but still the same problem. After reading the repair FAQ and
searching the forums, I'm thinking it could be the microcontroller or
a power supply problem. Does this sound likely, or could it be
something else?

The deck has a large outboard +/-15v DC-DC converter with power and
ground inputs, and then six wires going out to the deck:

In: yellow, black
Out: yellow, black, blue/yellow, black/white, yellow/red, yellow/black

All the connectors and wires test out ok. How should I go about
testing the power supply? From what I can tell, black and black/white
are both grounds, yellow is constant 12v memory to the deck, and
blue/yellow is remote turn-on for the converter. I checked the other
two wires for voltage with the deck on and got nothing on the
yellow/red, and 0.1v on the yellow/black. Also I can hear the
converter "motorboat" or hum quietly when it's on. Is this normal?

Any help or suggestions would be greatly appreciated.

Thanks,
Eric
I have seen quite a few of the flourescent backlights not work in
these units, but test the inverter voltages and the display controller
ic signals with an oscilloscope if you have one.

CD Player Display and Button Problem
 

Although it's a few years old, it was a fairly expensive unit when new
($1k+). I'll probably send it to Clarion for repair ($150) if it's the
processor. But if it's just the power supply, I'd like to try and
repair it myself or just buy a new PS.

Does it sound like the PS could be faulty, or is it not really
possible to tell without schematics?

I just noticed the display has four dim red lines running horizontally
across it. The VF display is normally a blue dot formation. This unit
is basically identical to the McIntosh MX406, if anyone happens to
have experience repairing those.

Thanks for the help.


"Jerry G." wrote in message ...
I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================

CD Player Display and Button Problem
 

Although it's a few years old, it was a fairly expensive unit when new
($1k+). I'll probably send it to Clarion for repair ($150) if it's the
processor. But if it's just the power supply, I'd like to try and
repair it myself or just buy a new PS.

Does it sound like the PS could be faulty, or is it not really
possible to tell without schematics?

I just noticed the display has four dim red lines running horizontally
across it. The VF display is normally a blue dot formation. This unit
is basically identical to the McIntosh MX406, if anyone happens to
have experience repairing those.

Thanks for the help.


"Jerry G." wrote in message ...
I would think at this point you will need to order the service manual from
Clarion, if they would sell it to you. Once you get past the power supply,
you will require the proper test gear and tools to follow through to
troubleshoot your unit. If this is a low cost unit, I would consider
retiring it.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================