Marshall MG100HDFX ,2002
Loss of clean channel intermittently, dirty channel ok.
Both clean switches have no contacts made in clean mode. I'll replace the clean vol control, but nothing obviously wrong. No obvious solder problems in that area. Anyone know if anything of the clean ch,separately, goes through the digital effects pcb.? 3 pcb fixings only on 3 of 4 corners, allowing one corner to lift with vibration, the header side. I'll reset pins and fit a cable tie over that corner (too populated to have a 4th fixing) When I can repower I'll remove the dsp board and see what that does |
All times are GMT +1. The time now is 10:41 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter