Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Electric toothbrush.
The rechargeable battery died on my electric toothbrush - after a few
minutes looking at prices online, I reached for the Dremel! A 4x AAA battery holder and some hot melt glue, and its working again, the difficulty arises from the 4x 1/3 AA battery assembly was as if a core to the pick up coil for the no leads charging stand. Unfortunately I neglected to refit the scrap battery, so the pick up coil no longer has a big fat shorted turn in the middle of it - when I stood it in the charging stand, the charge LED looked a bit over-bright. I could just take out the AAA cells and put them in a regular charger, but I kind of like the convenience of the charging stand. How bad can it be?! Thanks for any advice. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Oral B Electric Toothbrush | UK diy | |||
Boots electric toothbrush: how to open? | UK diy | |||
Boots electric toothbrush | UK diy | |||
Disconnect electric toothbrush | Home Repair | |||
electric toothbrush | UK diy |