I got tired of switching the leads of my DMM. Suddenly if dawned on
me that I can just set the power supply to 10.0V for exaample, and
read the current, and then divide the voltage by the current to find
the resistance. Like I put a resistance on the PS, it reads 10.0V and
the current is .018A, so 10 / .018 gives 555.6 ohms. Must be a 560
ohm resistor.

I turned my PS into an ohmmeter - FREE!

Hee-hee - Work smarter, not harder!

Of course, make sure the current stays low so the resistance doesn't
overheat. For low resistances use a volt or less.

--
@@F@r@o@m@@O@r@a@n@g@e@@C@o@u@n@t@y@,@@C@a@l@,@@w@ h@e@r@e@@
###Got a Question about ELECTRONICS? Check HERE First:###
http://users.pandora.be/educypedia/e...s/databank.htm
My email address is whitelisted. *All* email sent to it
goes directly to the trash unless you add NOSPAM in the
Subject: line with other stuff. alondra101 at hotmail.com
Don't be ripped off by the big book dealers. Go to the URL
that will give you a choice and save you money(up to half).
http://www.everybookstore.com You'll be glad you did!
Just when you thought you had all this figured out, the gov't
changed it: http://physics.nist.gov/cuu/Units/binary.html
@@t@h@e@@a@f@f@l@u@e@n@t@@m@e@e@t@@t@h@e@@E@f@f@l@ u@e@n@t@@