Sony DVP-C650D carousel out of alignment
 

What is frustrating is that I have fixed this before but can not for the life of me find the web page or forum that I found the fix again. My child pushed in the tray instead of using the eject button and this model specifically states you can not do that or you have to send it in to get it serviced. When I turn on the unit I hear a humming sound, 1st the door opens 1/4 of a inch then it opens 1 inch, then opens all the way, then closes to the 1 inch position, then tries to close, then finally opens all the way then stops. Before I seem to remember there was a setting to reset the player at it's home position. Something like with the power off push the tray to the closed position then when turning on the power hold down the CD1 button the play button and the eject button at the same time and the player would initialize / reset to the home position and then the carousel tray would work as it should. Can someone please tell me what the sequence is to realigning the carousel tray? I was shocked that the service repair manual does not mention anything about aligning the carousel tray but has tons of pages on aligning the laser and trouble shooting circuit boards.
Thanks,
Will

Sony DVP-C650D carousel out of alignment
 

"curiouslibra" wrote in message ...

I seem to remember there was a setting to reset the player at its
home position. Something like "With the power off, push the tray
to the closed position, then when turning on the power hold down
the CD1 button, the play button, and the eject button at the same
time, and the player would initialize / reset to the home position."

As you have nothing to lose... have you tried it?

Sony DVP-C650D carousel out of alignment
 

"curiouslibra" wrote in message
...

What is frustrating is that I have fixed this before but can not for the
life of me find the web page or forum that I found the fix again. My
child pushed in the tray instead of using the eject button and this
model specifically states you can not do that or you have to send it in
to get it serviced. When I turn on the unit I hear a humming sound, 1st
the door opens 1/4 of a inch then it opens 1 inch, then opens all the
way, then closes to the 1 inch position, then tries to close, then
finally opens all the way then stops. Before I seem to remember there
was a setting to reset the player at it's home position. Something like
with the power off push the tray to the closed position then when
turning on the power hold down the CD1 button the play button and the
eject button at the same time and the player would initialize / reset to
the home position and then the carousel tray would work as it should.
Can someone please tell me what the sequence is to realigning the
carousel tray? I was shocked that the service repair manual does not
mention anything about aligning the carousel tray but has tons of pages
on aligning the laser and trouble shooting circuit boards.
Thanks,
Will




--
curiouslibra


Not sure how to relate this in a usable way, but here goes.

(With Power OFF)

Often you can lift the center portion of the carousel and tray and sort of
bend them up above the teeth of the driving gear underneath. While doing
this, rotate the gears to where there is a gap or open section of the main
gear. Let the tray etc back down. At this point the tray should slide in and
out freely without being influenced by the gears. Might take a couple tries.

Then push the tray all the way to the rear, fully snug against the rear
panel. Turn the unit ON and the mechanism should reset.

If this does not work, your only choice is to remove the little keeper
brackets on the sides and just fool around with it until it works...

Mark Z.

Sony DVP-C650D carousel out of alignment
 

There is an alignment procedure for these units. It does require removing the tray though. Being off by one tooth will prevent this from working properly. Look for a copy of the service manual. IRRC, the procedure is shown in the manual.

Dan