Source for 2.5mm Right Angle TRRS 4 Pole Plugs
I've been attempting to locate some replacement/repair type 2.5mm right
angle/90 degree plugs and haven't found a supplier. I'd settle for pre-wired 4 conductor cables with molded R-A plugs if I could find something of decent quality. The plugs are needed to make a cable for audio, video, +5V and ground (the A/V grounds are common). I may end up needing to take straight plugs and discard the cover/strain relief, and form a R-A body from epoxy.. but basically no longer repairable. It's one of those aspects of small miniturized devices having straight plugs sticking out of them like antlers, defeating the compactness and inviting damaged internal cable jacks. Thanks -- Cheers, WB .............. |
Source for 2.5mm Right Angle TRRS 4 Pole Plugs
Wild_Bill wrote:
I purchased 2-4 pieces of several different versions with right-angle plugs from the supplier in Korea and hopefully they'll be fairly easy to modify for my AV plus power leads. Hope it works out! When I have made splitter or adapter cables like this in the past, I have used a 35 mm film canister as the "lump" in the middle where one cable breaks into several. This gives plenty of room for splicing. These days I am a little bit better at soldering, plus I don't know where to get 35 mm film canisters anymore, so I would probably use something smaller. Matt Roberds |
Source for 2.5mm Right Angle TRRS 4 Pole Plugs
For low voltage mini cables I'm using rounded, small pieces of sheet plastic
with hot melt glue sandwiched together to form a sealed junction block of sorts. An inline flat oval shape rarely snags on anything and reinforces the the cable strength. A box-like cover can be constructed with 3 shaped pieces of flat plastic, and carving out a hole and cable entry/exits in the center layer (rotary tool, Dremel, mini mill or engraving machine). When glued together the sections form a durable, sealed cover for the junction. Shielding could be fairly easily included if needed. Epoxy putty can be used, the kind that comes as a 2-part log, which a slice is removed and mashed/kneaded/mixed until it's a uniform color, then shaped around the junction. These epoxy products have a typical set-up time of 5 minutes although some are quicker. -- Cheers, WB .............. wrote in message ... When I have made splitter or adapter cables like this in the past, I have used a 35 mm film canister as the "lump" in the middle where one cable breaks into several. This gives plenty of room for splicing. These days I am a little bit better at soldering, plus I don't know where to get 35 mm film canisters anymore, so I would probably use something smaller. Matt Roberds |
All times are GMT +1. The time now is 09:13 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter