Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 5,247
Default Cyclic rattle and squeek in felt slip clutches

As the problem has been around all the decades ,from tape decks reel-to-reel
via cassette to VCR, I assume there is no cure other than replace with
unobtanium parts. But in case anyone here has any insight. Not a problem of
lack of lubrication on shaft or bearings. I suspect , perhaps only micron
level of ripple develops on the rubbing surface, anyone know the cause for
certain ? If that was the case then a light skim in a lathe perhaps. Is the
squuek noise enhanced by the compression spring ? Any known , even if
relatively shorterm fixes , not requiring taking apart


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Rattle Can ARRRRGGGGHHHHH. J. Clarke[_2_] Woodworking 19 July 15th 11 04:35 AM
BABY RATTLE J T Woodworking 0 November 12th 07 10:49 AM
Magnets and clutches _[_2_] Metalworking 9 August 2nd 07 04:32 PM
HDD 'died' cyclic redundancy error Eeyore Electronics Repair 100 July 26th 07 06:01 AM
Worcester Bosch 24 CDI rattle and hum Sean UK diy 3 October 3rd 05 11:17 AM


All times are GMT +1. The time now is 08:22 AM.

Powered by vBulletin® Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
Copyright 2004-2023 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"