Any TV experts here?

I'll post my question if there are!

This TV: Sony Bravia KDL 32EX503U

"~BD~" wrote in message
...
Any TV experts here?

I'll post my question if there are!

This TV: Sony Bravia KDL 32EX503U

There isn't really any such thing, these days. You take a flatscreen TV, and
you do what you can with it, based on experience. A lot of the time, its a
case of going down the manufacturers' preferred route, of board swapping.
That said, power supplies and backlight inverters are often repairable. So
what's the problem ? Good possibility that someone on here might know the
answer, or be able to point you in the right direction. If you never
actually ask the question, you'll never actually know ...

Arfa

On 10/31/2011 3:21 PM, ~BD~ wrote:
Any TV experts here?

I'll post my question if there are!

This TV: Sony Bravia KDL 32EX503U

I got quite good on repairing Philco 16 inch, black,and white, TVs back
in 1950s

Bill K7NOM

On 10/31/2011 9:41 PM, bill wrote:
On 10/31/2011 3:21 PM, ~BD~ wrote:
Any TV experts here?

I'll post my question if there are!

This TV: Sony Bravia KDL 32EX503U

I got quite good on repairing Philco 16 inch, black,and white, TVs back
in 1950s

Bill K7NOM

Nowadays, aren't most TV's a computer driven monitor.
Mikek :-)

It was working fine, then didn't work? This suggests a possible change in
reception conditions. You should definitely swap the sets, as suggested.

However...

You've lost SD reception (SD being 625-line PAL), but not HD, right? As far
as I know, SD and HD use separate tuners. (I think.) I could be that the SD
tuner has gone out.

"William Sommer******"


You've lost SD reception (SD being 625-line PAL), but not HD, right? As
far
as I know, SD and HD use separate tuners. (I think.) I could be that the
SD
tuner has gone out.


** The RF stages do not change with SD and HD.



..... Phil

You've lost SD reception (SD being 625-line PAL), but not HD,
right? As far as I know, SD and HD use separate tuners. (I think.)
I could be that the SD tuner has gone out.

** The RF stages do not change with SD and HD.

Do you mean just the front end, or the IF section, too?

Given his description, it's hard to believe it was caused only by a change
in signal level.

We'll have a better when he swaps the sets.

"William Sommerwaker "

You've lost SD reception (SD being 625-line PAL), but not HD,
right? As far as I know, SD and HD use separate tuners. (I think.)
I could be that the SD tuner has gone out.

** The RF stages do not change with SD and HD.

Do you mean just the front end, or the IF section, too?

Given his description, it's hard to believe it was caused only by a change
in signal level.


** Wot a ****wit.

On Sun, 6 Nov 2011 20:44:23 +1100, Phil Allison wrote:

** Wot a ****wit.

I am consantly impressed with your erudite contribution to this ng.