Pioneer DEH-P4600MP
Hello,
I have a DEH-P4600MP that I installed a IP Bus Ipod adapter (ip bus to 3.5 mini plug) on and it worked ok for a while. I think my iphone may have put to hot of a signal in the input of the E-Vol chip PML003. The unit will play all channels when it is first turned on, but after about 2-3 minutes the left side (front and rear) start to distort and then fades off. I have it apart and the E-Vol smt starts to get warm and then hot after about 2-3 mins. After it gets real hot the left side goes out. I have cooled it down with compressed air (can upside down) and the left side will start working again. Right side works all the time. There are a few caps around this chip and I was thinking it was a bad cap, but a bap cap(s) shouldn't make the chip get hot. I don't guess. I also used a ESR meter on the caps and they show the same values as the another unit I have. (4.7uf and 1uf at 50v) This is a SMT chip and I have another one on a spare unit. Any way... Does anyone have any ideas on this? I think it is a bad chip, but would like another opinion. Plus, I don't have a lot of experience removing and installing SMT chips. I do have a PDF of the service manual. TIA! |
All times are GMT +1. The time now is 10:58 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter