Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Posted to sci.electronics.repair
external usenet poster
 
Posts: 147
Default Toshiba TV model 27A44, Regulated B+ Info

Hi,

Note: Now I have the SM.

I fixed a lot of TVs over the years that had excessive HV, but this
Toshiba is out of the ordinary. All the parts that would normally cause
excessive HV in the horizontal sweep circuits tested fine. I removed parts
from the circuit to test. The flyback pulse width on the scope was normal,
within 11 to 14 usec at 10% from base. Note: Other FBT voltages were higher
than normal. The SM, "Basic Adjustments", states the regulated B+ should be
"+123 +/- .5V". This voltage, "+123V" or the HV, can not be found in any
schematic in this SM.

The filter capacitor in the regulated B+ was tested. Due to the time
already spent trying to repair this "DOG", I decided upon a couple
modifications to save this TV from going to the dump. I installed a 5 ohm,
5 watt resistor in the B+ line to the FBT. I also added a .0012uf 2KV
sweep cap across C412 .0027 1.25KV. Now the HV is around 27KV, which I
checked several times during a long run, and the TV has a good picture.

Brad

On Wed, 03 Dec 2008 14:56:54 GMT, Brad wrote:

Hi,

I have a Toshiba TV (27" pic) model 27A44 (mfg. 05/04) in my TV service
shop (no SM). Customer told me the TV "sparks" once in awhile, then turns
off. It didn't do it in the shop yet, but checking the HV, it was 30KV
(higher than normal). I checked the regulated B+ and it measured +122V!
Unfortunately, there is no marking on PCB that indicates what this voltage
should be.

I removed and tested the timing capacitors in the horizontal output
circuit. Sometimes an open capacitor will cause the HV to go higher
than normal. They tested just fine.

130V is very common in my experience, but can someone tell me what the
regulated B+ should be in this model TV?

Thanks in advance, Brad

Before you type your password, credit card number, etc.,
be sure there is no active keystroke logger (spyware) in your PC.


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Toshiba TV model 27A44, Regulated B+ Info Brad Electronics Repair 0 December 5th 08 06:06 PM
Toshiba TV model 27A44, Regulated B+ Info Brad Electronics Repair 2 December 4th 08 07:32 PM
Part Info Needed, Toshiba CRT TV [email protected] Electronics Repair 4 September 18th 06 11:24 PM
Info needed on Technics turntable & Toshiba amp. Bob Parker Electronics Repair 3 February 8th 04 04:14 PM
Toshiba RPTV 61A61 dead; need info bharat Electronics Repair 2 December 27th 03 05:42 PM


All times are GMT +1. The time now is 08:10 PM.

Powered by vBulletin® Copyright ©2000 - 2023, Jelsoft Enterprises Ltd.
Copyright 2004-2023 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"