DIYbanter

DIYbanter (https://www.diybanter.com/)
-   Electronics Repair (https://www.diybanter.com/electronics-repair/)
-   -   Fender de Luxe, PR 246, 2004 (https://www.diybanter.com/electronics-repair/198463-fender-de-luxe-google-page-ranking-246-2004-a.html)

n cook April 20th 07 07:39 AM

Fender de Luxe, PR 246, 2004
 
Only used , not abused, domestically, ie not bumped around ina van at any
time.
Mechanically broken dome end of GT badged Sovtek 5881, neat circular crack.
Black deposit around a jet out of the envelope matching a black deposit on
the metal "protection" cage screwed to the cab back panel. Gripper function
around valve base was fine. Not obviously valve/cage touching, but close, I
will reposition this cage 1/4 inch lower down. Is this a recognised
design/construction failing perhaps Russian 5881 a bit longer than 6L6.

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/



n cook April 20th 07 10:26 AM

Fender de Luxe, PR 246, 2004
 
N Cook wrote in message
...
Only used , not abused, domestically, ie not bumped around ina van at any
time.
Mechanically broken dome end of GT badged Sovtek 5881, neat circular

crack.
Black deposit around a jet out of the envelope matching a black deposit on
the metal "protection" cage screwed to the cab back panel. Gripper

function
around valve base was fine. Not obviously valve/cage touching, but close,

I
will reposition this cage 1/4 inch lower down. Is this a recognised
design/construction failing perhaps Russian 5881 a bit longer than 6L6.

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/



This model should have the plastic/wood composite back board braced back to
the front as it has 2 large openings that seriously weaken it, but the
speaker is in the way. Or a vertical bar from top to bottom to prevent the
panel flexing inwards if pushed up against something.
Have repositioned the "protection" cage down 1/4 inch and bent the
horizontal part of the cage downwards a bit to give about 3/4 inch clearance
from the bottles when no flexure of the back board.

--
Diverse Devices, Southampton, England
electronic hints and repair briefs , schematics/manuals list on
http://home.graffiti.net/diverse:graffiti.net/




All times are GMT +1. The time now is 08:42 PM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter