Packard Bell Tft Monitor FT500 Problem
 

I have a problem with monitor as follows:
When switched on at mains - on/off green indicator light cycles on for
5secs then off for 1.5 secs then repeats sequence for as long as power
is applied.
The screen remains black except for slight flicker initially.
The PSU and Inverter pcb is a Frontek FLF 1542-02A and although this
looks OK from a visual inspection (no burnt components etc) so wonder
if there are any other checks that anyone can suggest - bearing in mind
that this is a home cure job not workshop.
The monitor is a 2003 model with Part No 6901830000

Probably easier to bin it and get a new one - but theres no challenge
in that.
Stuart2z9sl (Gloucestershire - UK)


--
stuart2z9sl
------------------------------------------------------------------------
stuart2z9sl's Profile: http://www.futurehardware.in/member.php?userid=176
View this thread: http://www.futurehardware.in/showthread.php?t=547628

Future Hardware - http://www.futurehardware.in

Packard Bell Tft Monitor FT500 Problem
 

stuart2z9sl wrote:
I have a problem with monitor as follows:
When switched on at mains - on/off green indicator light cycles on for
5secs then off for 1.5 secs then repeats sequence for as long as power
is applied.
The screen remains black except for slight flicker initially.
The PSU and Inverter pcb is a Frontek FLF 1542-02A and although this
looks OK from a visual inspection (no burnt components etc) so wonder
if there are any other checks that anyone can suggest - bearing in mind
that this is a home cure job not workshop.
The monitor is a 2003 model with Part No 6901830000

Probably easier to bin it and get a new one - but theres no challenge
in that.
Stuart2z9sl (Gloucestershire - UK)


--
stuart2z9sl
------------------------------------------------------------------------

It sounds most likely that the inverter is bad. Troubleshooting these
things is not usually possible....best to replace it. If you cannot
find the exact part, something designed for the same size monitor and
number/size of CCFL tubes will probably work...with some mechanical
adaption.

Packard Bell Tft Monitor FT500 Problem
 

To webpa:

Thanks for the info.
Had a feeling that it would not be something simple.
Did not cost much to begin with (ex Ebay) so not worth messing around
with.
Will bin it and buy a new one - NOT Ebay.

Thanks again
Regards - Stuart


--
stuart2z9sl
------------------------------------------------------------------------
stuart2z9sl's Profile: http://www.futurehardware.in/member.php?userid=176
View this thread: http://www.futurehardware.in/showthread.php?t=547628

Future Hardware - http://www.futurehardware.in

Packard Bell Tft Monitor FT500 Problem
 

in english:
also I have the same problem, black screen and the key power that it is
ignited and is extinguished. it could be the local power supply?

in italian:
anche io ho lo stesso problema ,schermo nero ed il tasto power che si
accende e si spegne. potrebbe essere l' alimentatore?

stuart2z9sl ha scritto:

To webpa:

Thanks for the info.
Had a feeling that it would not be something simple.
Did not cost much to begin with (ex Ebay) so not worth messing around
with.
Will bin it and buy a new one - NOT Ebay.

Thanks again
Regards - Stuart


--
stuart2z9sl
------------------------------------------------------------------------
stuart2z9sl's Profile: http://www.futurehardware.in/member.php?userid=176
View this thread: http://www.futurehardware.in/showthread.php?t=547628

Future Hardware - http://www.futurehardware.in