Sylvania (Funai) TV 6420FE Goes Off Right After Turned On
 

Hi,

I used (did this many times in the past) an adjustable 250 ohm 200W
industrial type resistor as a load with H.O.T. out of circuit, but the results
are still the same. Reg B+ goes to +115V at turn on for about a second, then
the Reg B+ drops back to the standby level (around 50 volts).

Brad

On Tue, 20 Jun 2006 15:22:45 +0200, in sci.electronics.repair you wrote:

In data Mon, 19 Jun 2006 22:25:03 +0200, Brad ha
scritto:

Hi,

I have a Sylvania (Funai) TV model 6420FE (mfg 01/05) in
my shop. Note: I do not have a SM for this set.

The TV goes off about a second after it is turned on. There
is HV and the regulated B+ goes to +115V at turn on. There
is vertical deflection based on the "buzz" sound I "picked up"
near the yoke. Anyone fix one of these with the same symptom?ù

Try to remove the HOT and connect a 60 Watt 240V or two 60 Watt 120V lamps
in series
one wire where was the collector, and the other wire at the ground.

Thanks in advance, Brad

Before you type your password, credit card number, etc.,
be sure there is no active key logger (spyware) in your PC.