Hamilton Beach blender--lubricate?
 

Hamilton Beach blenders have a cutter assembly that consists of the blades
mounted on a shaft in a bearing surrounded by molded plastic.

After some period of time, the shaft siezes on the bearing and the cutters
won't spin.

The shaft seems to be sealed (to keep out whatever liquid is being blended)
so I haven't been able to get any WD-40 or oil into the shaft/bearing to
free it up.

Has anyone succeeded in re-lubricating the cutter assembly?

The only alternative is to buy a replacement ($8 at Wal-Mart).

Hamilton Beach blender--lubricate?
 

Jim Land writes:

Hamilton Beach blenders have a cutter assembly that consists of the blades
mounted on a shaft in a bearing surrounded by molded plastic.

After some period of time, the shaft siezes on the bearing and the cutters
won't spin.

The shaft seems to be sealed (to keep out whatever liquid is being blended)
so I haven't been able to get any WD-40 or oil into the shaft/bearing to
free it up.

Has anyone succeeded in re-lubricating the cutter assembly?

The only alternative is to buy a replacement ($8 at Wal-Mart).

Probably just gummed up solid from not being cleaned properly after use?

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.