Replacing motherboard capacitors
 

Just tried powering up an old (386) PC, and was greeted with an acrid
smell and a puff of smoke; one of the motherboard capacitors had blown.
I'd like to try replacing it, but my main concern is: what rating
should I buy as a replacement? The surviving originals are all marked
"10+ 16J".

--
John Elliott

Replacing motherboard capacitors
 

wrote in message
oups.com...
Just tried powering up an old (386) PC, and was greeted with an acrid
smell and a puff of smoke; one of the motherboard capacitors had blown.
I'd like to try replacing it, but my main concern is: what rating
should I buy as a replacement? The surviving originals are all marked
"10+ 16J".

10 microfarads @ 16 volts (just a guess).

Replacing motherboard capacitors
 

they are tantalium caps, replace with another tantalium.

Replacing motherboard capacitors
 

"inty's world" wrote in message
oups.com...
they are tantalium caps, replace with another tantalium.


I'd replace them with electrolytics unless there's very good reason why
tants are essential. As they smoked I'd assume they're across the supply, ie
filter caps, so as long as they physically fit, electrolytics are a
reasonable choice for replacement.

Tantalum caps have very high failure rates, and worse still they often fail
short circuit. I never use them unless I have to.

Dave

Replacing motherboard capacitors
 

wrote in message
oups.com...
Just tried powering up an old (386) PC, and was greeted with an acrid
smell and a puff of smoke; one of the motherboard capacitors had blown.
I'd like to try replacing it, but my main concern is: what rating
should I buy as a replacement? The surviving originals are all marked
"10+ 16J".

--
John Elliott


The last PC I had do that - the PSU regulation had failed!

Replacing motherboard capacitors
 

On 29 Mar 2006 12:42:04 -0800, "
wrote:

Just tried powering up an old (386) PC, and was greeted with an acrid
smell and a puff of smoke; one of the motherboard capacitors had blown.
I'd like to try replacing it, but my main concern is: what rating
should I buy as a replacement? The surviving originals are all marked
"10+ 16J".


That's a 10 uF 16 volt tantalum cap. They tend to be very reliable,
but when they do fail, they short and smoke. A tantalum cap would be
best, but any decent 10 uF 16 v cap should work in that application.

There's no need to replace any other caps if only one failed. This
isn't like the more recent motherboard that were made with dozens of
defective caps.

As a quick test, you can try removing the cap. Chances are the PC
will at least POST without it.

When you replace it, note that the stripe on a tantalum cap identifies
the positive side, but most other caps have the stripe on the negative
side.
Andy Cuffe