Hameg HM408 Oscilloscope help
Hi,
i've a Hameg HM408 oscilloscoper analog /digital. The problem is this: in analog mode all it's ok. When i use the digital mode the waweform is terrible distorted,all 2 traces has a noise(it seem a 50 HZ noise). What could be??? Thanks for any help. MAX |
Hameg HM408 Oscilloscope help
Hard to say without looking at the waveform. Some of it may be due to
general sampling or quantization errors. How's about you put it in analog mode, then probe around the power supply and see if the power supply voltages are okay, especially around the digital circuitry? |
Hameg HM408 Oscilloscope help
HI,
thanks! I've checked all supply voltage and semms to be ok. Another strange thing(always in digital mode) is that when i move the trace in the upper zone of the crt the noise linked to signal is little. When i move the trace in the lower zone of the crt the noise linked to signal under test,is terribly magnified!! mah............. |
All times are GMT +1. The time now is 04:56 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter