Beko TV Fault
 

Model number 284248WNS
Powers up ok then immediately the screen has a yellow tint then changes to
red then blue...goes out of focus and back to normal..cycles like this
..takes about 6 seconds to go through a complete cycle.
any ideas

Beko TV Fault
 

This could be a cold solder on the CRT socket assembly, bad connection
between the focus grid of the CRT back to the focus supply, or a defect in
the high voltage multiplier, and or the CRT may be failing.

If you are not experienced in TV servicing and equipped to do so, it is best
to give the set out for proper service. There are some serious safety issues
with working inside of TV sets.

--

JANA
_____


"simon hanlon" wrote in message
...
Model number 284248WNS
Powers up ok then immediately the screen has a yellow tint then changes to
red then blue...goes out of focus and back to normal..cycles like this
..takes about 6 seconds to go through a complete cycle.
any ideas

Beko TV Fault
 

On further inspection it seems the brightness has gone strange, when you
turn it down on the remote it is still bright but stops the cycling of
colour tints. It is still slightly out of focus also

"JANA" wrote in message
...
This could be a cold solder on the CRT socket assembly, bad connection
between the focus grid of the CRT back to the focus supply, or a defect in
the high voltage multiplier, and or the CRT may be failing.

If you are not experienced in TV servicing and equipped to do so, it is
best
to give the set out for proper service. There are some serious safety
issues
with working inside of TV sets.

--

JANA
_____


"simon hanlon" wrote in message
...
Model number 284248WNS
Powers up ok then immediately the screen has a yellow tint then changes to
red then blue...goes out of focus and back to normal..cycles like this
.takes about 6 seconds to go through a complete cycle.
any ideas

Beko TV Fault
 

Chassis ?

Beko TV Fault
 

Model number 284248WNS
chassis Beko 14.2 I think
wrote in message
oups.com...
Chassis ?

Beko TV Fault
 

Read your emails